lkml.org 
[lkml]   [2020]   [Apr]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1] net: phy: micrel: kszphy_resume(): add delay after genphy_resume() before accessing PHY registers
From
From: Oleksij Rempel <o.rempel@pengutronix.de>
Date: Fri, 3 Apr 2020 09:53:25 +0200

> After the power-down bit is cleared, the chip internally triggers a
> global reset. According to the KSZ9031 documentation, we have to wait at
> least 1ms for the reset to finish.
>
> If the chip is accessed during reset, read will return 0xffff, while
> write will be ignored. Depending on the system performance and MDIO bus
> speed, we may or may not run in to this issue.
>
> This bug was discovered on an iMX6QP system with KSZ9031 PHY and
> attached PHY interrupt line. If IRQ was used, the link status update was
> lost. In polling mode, the link status update was always correct.
>
> The investigation showed, that during a read-modify-write access, the
> read returned 0xffff (while the chip was still in reset) and
> corresponding write hit the chip _after_ reset and triggered (due to the
> 0xffff) another reset in an undocumented bit (register 0x1f, bit 1),
> resulting in the next write being lost due to the new reset cycle.
>
> This patch fixes the issue by adding a 1...2 ms sleep after the
> genphy_resume().
>
> Fixes: 836384d2501d ("net: phy: micrel: Add specific suspend")
> Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>

Applied and queued up for -stable, thank you.

\
 
 \ /
  Last update: 2020-04-04 01:06    [W:0.046 / U:1.232 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site