lkml.org 
[lkml]   [2020]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [linux-sunxi] [PATCH] media: cedrus: Implement runtime PM
From
Date
On 4/8/20 11:01 AM, Jernej Škrabec wrote:
> Hi Samuel!
>
> Dne sreda, 08. april 2020 ob 03:02:32 CEST je Samuel Holland napisal(a):
>> This allows the VE clocks and PLL_VE to be disabled most of the time.
>>
>> Since the device is stateless, each frame gets a separate runtime PM
>> reference. Enable autosuspend so the PM callbacks are not run before and
>> after every frame.
>>
>> Signed-off-by: Samuel Holland <samuel@sholland.org>
>> ---
>>
>> I tested this with v4l2-request-test. I don't have the setup to do
>> anything more complicated at the moment.
>>
>> ---
>> drivers/staging/media/sunxi/cedrus/cedrus.c | 7 ++
>> .../staging/media/sunxi/cedrus/cedrus_hw.c | 115 ++++++++++++------
>> .../staging/media/sunxi/cedrus/cedrus_hw.h | 3 +
>> 3 files changed, 88 insertions(+), 37 deletions(-)

[snip]

> Reset above causes problem. When format is set in cedrus_s_fmt_vid_cap() a
> function is called, which sets few registers in HW. Of course, there is no
> guarantee that someone will start decoding immediately after capture format is
> set. So, if the driver puts VPU to sleep in the mean time, reset will clear
> those registers and decoded video will be in different format than expected. It
> could be even argued that registers should not be set in that function and
> that this is design issue or bug in driver.

You're right. I didn't see that cedrus_dst_format_set() was called outside
cedrus_engine_enable/disable().

> Anyway, I made a runtime PM support long time ago, but never do anything
> besides running few tests:
> https://github.com/jernejsk/linux-1/commit/
> d245b7fa2a26e519ff675a255c45230575a4a848
>
> It takes a bit different approach. Power is enabled in start streaming and
> disabled in stop streaming. This is simpler approach and doesn't need
> autosuspend functionality. I also moved call to a function which sets format
> in HW registers to start streaming handler, so it's guaranteed to be set at
> the beginning.

Assuming cedrus_device_run() only gets called between streamon and streamoff
(which appears to be the case), this looks like a better design.

> Note that some registers are only set in start streaming handler. With your
> approach, if first frame is submitted too late, asserting and de-asserting
> reset line could reset those registers.

I only see registers being set in cedrus_start_streaming() after your patch,
where you add a call to cedrus_dst_format_set(). I can't find any registers
being written in any of the ->start() callbacks.

I'll send a v2 which combines the two patches: yours which handles the runtime
part better, and mine which handles the probe/remove part better with !CONFIG_PM.

> Best regards,
> Jernej

Thanks for the review!
Samuel

\
 
 \ /
  Last update: 2020-04-19 22:28    [W:0.196 / U:0.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site