Messages in this thread | | | Date | Mon, 09 Mar 2020 20:13:33 -0700 (PDT) | Subject | Re: [PATCH net-next 0/8] net: Add support for Synopsys DesignWare XPCS | From | David Miller <> |
| |
From: Jose Abreu <Jose.Abreu@synopsys.com> Date: Mon, 9 Mar 2020 09:36:19 +0100
> This adds support for Synopsys DesignWare XPCS in net subsystem and > integrates it into stmmac. > > At 1/8, we start by removing the limitation of stmmac selftests that needed > a PHY to pass all the tests. > > Then at 2/8 we use some helpers in stmmac so that some code can be > simplified. > > At 3/8, we fallback to dev_fwnode() so that PCI based setups wich may > not have CONFIG_OF can still use FW node. > > At 4/8, we adapt stmmac to the new PHYLINK changes as suggested by Russell > King. > > We proceed by doing changes in PHYLINK in order to support XPCS: At 5/8 we > add some missing speeds that USXGMII supports and at 6/8 we check if > Autoneg is supported after initial parameters are validated. > > Support for XPCS is finally introduced at 7/8, along with the usage of it > in stmmac driver at 8/8.
Series applied, thank you.
| |