Messages in this thread | | | From | Masahiro Yamada <> | Date | Sun, 8 Mar 2020 11:18:41 +0900 | Subject | Re: [PATCH 2/3] kbuild: allow to run dt_binding_check and dtbs_check in a single command |
| |
Hi Sam, Rob,
On Thu, Mar 5, 2020 at 12:19 AM Rob Herring <robh+dt@kernel.org> wrote: > > On Tue, Mar 3, 2020 at 11:55 PM Sam Ravnborg <sam@ravnborg.org> wrote: > > > > Hi Masahiro > > > > Thanks for the nice improvements to the dt infrastructure. > > > > Stealing a thread here.. > > > > > It is also possible to run checks with a single schema file by setting the > > > ``DT_SCHEMA_FILES`` variable to a specific schema file. > > Would it be simple to enable the use of dirs for DT_SCHEMA_FILES? > > I did name that with the intent of supporting more than one file. > > > So I for example could do: > > > > make dt_bindings_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/display/panel/ > > Does this work?: > > make dt_bindings_check DT_SCHEMA_FILES="$(find > Documentation/devicetree/bindings/display/panel/ -name '*.yaml' | > xargs)" > > Rob
Rob proposed a solution, so I do not think we should extend this too much.
BTW, there is a limitation that DT_SCHEMA_FILES must point to file(s) in Documentation/devicetree/bindings/.
$ cp Documentation/devicetree/bindings/arm/psci.yaml ./ $ make dt_binding_check DT_SCHEMA_FILES=psci.yaml SCHEMA Documentation/devicetree/bindings/processed-schema.yaml make[1]: *** No rule to make target 'Documentation/devicetree/bindings/psci.yaml', needed by '__build'. Stop. make: *** [Makefile:1278: dt_binding_check] Error 2
$(patsubst $(src)/%.yaml,%.example.dts, $(DT_SCHEMA_FILES)) does not work if DT_SCHEMA_FILES is outside of Documentation/devicetree/bindings/, but I have no solution for this.
-- Best Regards Masahiro Yamada
| |