lkml.org 
[lkml]   [2020]   [Mar]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH net-next v3 08/11] net: ethernet: ti: cpts: move rx timestamp processing to ptp worker only
From
Date
Hi Richard

On 24/03/2020 18:54, Richard Cochran wrote:
> On Tue, Mar 24, 2020 at 05:34:34PM +0200, Grygorii Strashko wrote:
>> I tested both ways and kept this version as i'v not seen any degradation,
>> but, of course, i'll redo the test (or may be you can advise what test to run).
>
> Measure the time delay from when the frame arrives in the stack until
> that frame+RxTimestamp arrives in the application. I expect the round
> about way via kthread takes longer.
>
>> My thoughts were - network stack might not immediately deliver packet to the application
>
> The network stack always delivers the packet, but you artificially
> delay that delivery by calling netif_receive_skb() later on from
> cpts_match_rx_ts().
>
>> and PTP worker can be tuned (pri and smp_affinity),
>
> That won't avoid the net softirq.
>
>> resulted code will be more structured,
>
> I am afraid people will copy this pattern in new drivers. It really
> does not make much sense.

I did additional testing and will drop this patch.
Any other comments from you side?

Thank you.

--
Best regards,
grygorii

\
 
 \ /
  Last update: 2020-03-26 12:16    [W:0.055 / U:1.500 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site