lkml.org 
[lkml]   [2020]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 5/7] dt-bindings: serial: Add binding for rs485 receiver enable GPIO
Date
From: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>

RS485 has two signals to control transmissions "drivee enable" (RE) and
"receiver enable" (DE). RE is already handled via the uarts RTS signal
while RE signal on most implementations doesn't get handled separately
at all.

As there still will be cases where this is needed though add a gpio
property for declaring this signal pin.

Signed-off-by: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>
---
Documentation/devicetree/bindings/serial/rs485.yaml | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index a9ad17864889..e55730de796d 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml
@@ -44,6 +44,10 @@ properties:
description: enables the receiving of data even while sending data.
$ref: /schemas/types.yaml#/definitions/flag

+ rs485-rx-enable-gpios:
+ description: GPIO to handle a separate RS485 receive enable signal
+ $ref: /schemas/types.yaml#/definitions/flag
+
rs485-term-gpios:
description: GPIO pin to enable RS485 bus termination.
maxItems: 1
--
2.24.1
\
 
 \ /
  Last update: 2020-03-26 00:15    [W:0.104 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site