Messages in this thread | | | Subject | Re: [PATCH v17 09/12] PCI/AER: Allow clearing Error Status Register in FF mode | From | Kuppuswamy Sathyanarayanan <> | Date | Wed, 11 Mar 2020 16:07:59 -0700 |
| |
Hi Bjorn,
Re-sending the response in text mode.
On 3/11/20 3:23 PM, Bjorn Helgaas wrote: > Is any synchronization needed here between the EDR path and the > hotplug/enumeration path? If we want to follow the implementation note step by step (in sequence) then we need some synchronization between EDR path and enumeration path. But if its OK the achieve the same end result by following steps out of sequence then we don't need to create any dependency between EDR and enumeration paths. Currently we follow the later approach.
For example, consider the case in flow chart where after sending success _OST, firmware decides to stop the recovery of the device.
if we follow the flow chart as its then the steps should be,
1. clear the DPC status trigger 2. Send success code via _OST, and wait for return from _OST 3. if successful return then enumerate the child devices and reassign bus numbers.
In current approach the steps followed are,
1. Clear the DPC status trigger. 2. Send success code via _OST 2. In parallel, LINK UP event path will enumerate the child devices. 3. if firmware decides not to recover the device, then LINK DOWN event will eventually remove them again.
-- Sathyanarayanan Kuppuswamy Linux kernel developer
| |