lkml.org 
[lkml]   [2020]   [Feb]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v10 1/2] dt-bindings: spi: Add schema for Cadence QSPI Controller driver
From
Date
Hi Rob,

     Thank you for the review comments...

On 24/2/2020 11:54 PM, Rob Herring wrote:
> On Tue, Feb 18, 2020 at 8:29 PM Ramuthevar,Vadivel MuruganX
> <vadivel.muruganx.ramuthevar@linux.intel.com> wrote:
>> From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
> Cc the DT list if you want this reviewed.
Sorry,  next patch will add DT list in CC.
>> Add dt-bindings documentation for Cadence-QSPI controller to support
>> spi based flash memories.
>>
>> Signed-off-by: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
>> ---
>> .../devicetree/bindings/spi/cdns,qspi-nor.yaml | 147 +++++++++++++++++++++
>> 1 file changed, 147 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
>>
>> diff --git a/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml b/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
>> new file mode 100644
>> index 000000000000..1a4d6e8d0d0b
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
>> @@ -0,0 +1,147 @@
>> +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
>> +%YAML 1.2
>> +---
>> +$id: "http://devicetree.org/schemas/spi/cdns,qspi-nor.yaml#"
>> +$schema: "http://devicetree.org/meta-schemas/core.yaml#"
>> +
>> +title: Cadence QSPI Flash Controller support
>> +
>> +maintainers:
>> + - Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
>> +
>> +allOf:
>> + - $ref: "spi-controller.yaml#"
>> +
>> +description: |
>> + Binding Documentation for Cadence QSPI controller,This controller is
>> + present in the Intel LGM, Altera SoCFPGA and TI SoCs and this driver
>> + has been tested On Intel's LGM SoC.
>> +
>> + - compatible : should be one of the following:
>> + Generic default - "cdns,qspi-nor".
>> + For TI 66AK2G SoC - "ti,k2g-qspi", "cdns,qspi-nor".
>> + For TI AM654 SoC - "ti,am654-ospi", "cdns,qspi-nor".
>> + For Intel LGM SoC - "intel,lgm-qspi", "cdns,qspi-nor".
>> +
>> +properties:
>> + compatible:
>> + oneOf:
>> + - items:
>> + - enum:
>> + - ti,k2g-qspi
>> + - const: cdns,qspi-nor
>> +
>> + - items:
>> + - enum:
>> + - ti,am654-ospi
>> + - const: cdns,qspi-nor
>> +
>> + - items:
>> + - enum:
>> + - intel,lgm-qspi
>> + - const: cdns,qspi-nor
>> +
>> + - items:
>> + - const: cdns,qspi-nor
>> +
>> + reg:
>> + maxItems: 2
>> +
>> + interrupts:
>> + maxItems: 1
>> +
>> + clocks:
>> + maxItems: 1
>> +
>> + cdns,fifo-depth:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description:
>> + Size of the data FIFO in words.
> A 4GB fifo is valid? Add some constraints.
128 is valid, will update.
>> +
>> + cdns,fifo-width:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description:
>> + Bus width of the data FIFO in bytes.
> Add some constraints.
4 is valid , will fix it.
>> +
>> + cdns,trigger-address:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description:
>> + 32-bit indirect AHB trigger address.
>> +
>> + cdns,rclk-en:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description: |
>> + Flag to indicate that QSPI return clock is used to latch the read data
>> + rather than the QSPI clock. Make sure that QSPI return clock is populated
>> + on the board before using this property.
>> +
>> +# subnode's properties
>> +patternProperties:
>> + "^.*@[0-9a-fA-F]+$":
>> + type: object
>> + description:
>> + flash device uses the subnodes below defined properties.
>> +
>> + cdns,read-delay:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description:
>> + Delay for read capture logic, in clock cycles.
> 4 billion clock delay is valid?
based on the ref_clk , will add it.
>> +
>> + cdns,tshsl-ns:
>> + $ref: /schemas/types.yaml#/definitions/uint32
> You can drop this, anything with a standard unit suffix already has a type.
sure , will drop it.
>> + description: |
>> + Delay in nanoseconds for the length that the master mode chip select
>> + outputs are de-asserted between transactions.
> Constraints...?

50ns, will add it.

Regards
Vadivel
>> +
>> + cdns,tsd2d-ns:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description: |
>> + Delay in nanoseconds between one chip select being de-activated
>> + and the activation of another.
>> +
>> + cdns,tchsh-ns:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description: |
>> + Delay in nanoseconds between last bit of current transaction and
>> + deasserting the device chip select (qspi_n_ss_out).
>> +
>> + cdns,tslch-ns:
>> + $ref: /schemas/types.yaml#/definitions/uint32
>> + description: |
>> + Delay in nanoseconds between setting qspi_n_ss_out low and
>> + first bit transfer.
>> +
>> +required:
>> + - compatible
>> + - reg
>> + - interrupts
>> + - clocks
>> + - cdns,fifo-depth
>> + - cdns,fifo-width
>> + - cdns,trigger-address
>> +
>> +examples:
>> + - |
>> + qspi: spi@ff705000 {
>> + compatible = "cdns,qspi-nor";
>> + #address-cells = <1>;
>> + #size-cells = <0>;
>> + reg = <0xff705000 0x1000>,
>> + <0xffa00000 0x1000>;
>> + interrupts = <0 151 4>;
>> + clocks = <&qspi_clk>;
>> + cdns,fifo-depth = <128>;
>> + cdns,fifo-width = <4>;
>> + cdns,trigger-address = <0x00000000>;
>> +
>> + flash0: n25q00@0 {
>> + compatible = "jedec,spi-nor";
>> + reg = <0x0>;
>> + cdns,read-delay = <4>;
>> + cdns,tshsl-ns = <50>;
>> + cdns,tsd2d-ns = <50>;
>> + cdns,tchsh-ns = <4>;
>> + cdns,tslch-ns = <4>;
>> + };
>> + };
>> +
>> --
>> 2.11.0
>>

\
 
 \ /
  Last update: 2020-02-25 07:25    [W:0.067 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site