lkml.org 
[lkml]   [2020]   [Feb]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 0/6] Add ACPI bindings to the genet
From
Date
On 2/24/20 2:53 PM, Jeremy Linton wrote:
> This patch series allows the BCM GENET, as used on the RPi4,
> to attach when booted in an ACPI environment. The DSDT entry to
> trigger this is seen below. Of note, the first patch adds a
> small extension to the mdio layer which allows drivers to find
> the mii_bus without firmware assistance. The fifth patch in
> the set retrieves the MAC address from the umac registers
> rather than carrying it directly in the DSDT. This of course
> requires the firmware to pre-program it, so we continue to fall
> back on a random one if it appears to be garbage.

Thanks for your persistence on this I was able to apply this to the
latest net-next tree and give this a spin on a STB chip (which uses DT)
and did not see any issues, so:

Tested-by: Florian Fainelli <f.fainelli@gmail.com>

Thanks!
--
Florian

\
 
 \ /
  Last update: 2020-02-25 00:10    [W:0.034 / U:0.812 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site