lkml.org 
[lkml]   [2020]   [Feb]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH net-next 1/4] net: hns3: modify an unsuitable print when setting unknown duplex to fibre
Date
From: Guangbin Huang <huangguangbin2@huawei.com>

Currently, if device is in link down status and user uses
'ethtool -s' command to set speed but not specify duplex
mode, the duplex mode passed from ethtool to driver is
unknown value(255), and the fibre port will identify this
value as half duplex mode and print "only copper port
supports half duplex!". This message is confusing.

So for fibre port, only the setting duplex is half, prints
error and returns.

Signed-off-by: Guangbin Huang <huangguangbin2@huawei.com>
Signed-off-by: Huazhong Tan <tanhuazhong@huawei.com>
---
drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
index c03856e..3f59a19 100644
--- a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
@@ -736,7 +736,7 @@ static int hns3_check_ksettings_param(const struct net_device *netdev,
if (ops->get_media_type)
ops->get_media_type(handle, &media_type, &module_type);

- if (cmd->base.duplex != DUPLEX_FULL &&
+ if (cmd->base.duplex == DUPLEX_HALF &&
media_type != HNAE3_MEDIA_TYPE_COPPER) {
netdev_err(netdev,
"only copper port supports half duplex!");
--
2.7.4
\
 
 \ /
  Last update: 2020-02-19 02:24    [W:0.047 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site