lkml.org 
[lkml]   [2020]   [Feb]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] gpio: xilinx: Add irq support to the driver
Date
Allocate single chip for both channels.
Add irq support to the driver.
Supporting rising edge interrupts and in cascade mode supporting
first channel for interrupts on 32bit machines.

Signed-off-by: Srinivas Neeli <srinivas.neeli@xilinx.com>
---
drivers/gpio/gpio-xilinx.c | 233 ++++++++++++++++++++++++++++++++++++++++++++-
1 file changed, 232 insertions(+), 1 deletion(-)

diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c
index 26753ae58295..f6dd316b2c62 100644
--- a/drivers/gpio/gpio-xilinx.c
+++ b/drivers/gpio/gpio-xilinx.c
@@ -16,6 +16,11 @@
#include <linux/slab.h>
#include <linux/pm_runtime.h>
#include <linux/clk.h>
+#include <linux/of_irq.h>
+#include <linux/interrupt.h>
+#include <linux/irq.h>
+#include <linux/irqchip/chained_irq.h>
+#include <linux/irqdomain.h>

/* Register Offset Definitions */
#define XGPIO_DATA_OFFSET (0x0) /* Data register */
@@ -23,8 +28,13 @@

#define XGPIO_CHANNEL_OFFSET 0x8

+#define XGPIO_GIER_OFFSET 0x11c /* Global Interrupt Enable */
+#define XGPIO_GIER_IE BIT(31)
+#define XGPIO_IPISR_OFFSET 0x120 /* IP Interrupt Status */
+#define XGPIO_IPIER_OFFSET 0x128 /* IP Interrupt Enable */
+
/* Read/Write access to the GPIO registers */
-#if defined(CONFIG_ARCH_ZYNQ) || defined(CONFIG_X86)
+#if defined(CONFIG_ARCH_ZYNQ) || defined(CONFIG_X86) || defined(CONFIG_ARM64)
# define xgpio_readreg(offset) readl(offset)
# define xgpio_writereg(offset, val) writel(val, offset)
#else
@@ -41,7 +51,11 @@
* @gpio_dir: GPIO direction shadow register
* @gpio_lock: Lock used for synchronization
* @clk: clock resource for this driver
+ * @irq_base: GPIO channel irq base address
+ * @irq_enable: GPIO irq enable/disable bitfield
+ * @irq_domain: irq_domain of the controller
*/
+
struct xgpio_instance {
struct gpio_chip gc;
void __iomem *regs;
@@ -50,6 +64,9 @@ struct xgpio_instance {
u32 gpio_dir[2];
spinlock_t gpio_lock[2]; /* For serializing operations */
struct clk *clk;
+ int irq_base;
+ u32 irq_enable;
+ struct irq_domain *irq_domain;
};

static inline int xgpio_index(struct xgpio_instance *chip, int gpio)
@@ -324,6 +341,211 @@ static const struct dev_pm_ops xgpio_dev_pm_ops = {
};

/**
+ * xgpiops_irq_mask - Write the specified signal of the GPIO device.
+ * @irq_data: per irq and chip data passed down to chip functions
+ */
+static void xgpio_irq_mask(struct irq_data *irq_data)
+{
+ unsigned long flags;
+ struct xgpio_instance *chip = irq_data_get_irq_chip_data(irq_data);
+ u32 offset = irq_data->irq - chip->irq_base;
+ u32 temp;
+ s32 val;
+ int index = xgpio_index(chip, 0);
+
+ pr_debug("%s: Disable %d irq, irq_enable_mask 0x%x\n",
+ __func__, offset, chip->irq_enable);
+
+ spin_lock_irqsave(&chip->gpio_lock[index], flags);
+
+ chip->irq_enable &= ~BIT(offset);
+
+ if (!chip->irq_enable) {
+ /* Enable per channel interrupt */
+ temp = xgpio_readreg(chip->regs + XGPIO_IPIER_OFFSET);
+ val = offset - chip->gpio_width[0] + 1;
+ if (val > 0)
+ temp &= 1;
+ else
+ temp &= 2;
+ xgpio_writereg(chip->regs + XGPIO_IPIER_OFFSET, temp);
+
+ /* Disable global interrupt if channel interrupts are unused */
+ temp = xgpio_readreg(chip->regs + XGPIO_IPIER_OFFSET);
+ if (!temp)
+ xgpio_writereg(chip->regs + XGPIO_GIER_OFFSET,
+ ~XGPIO_GIER_IE);
+ }
+ spin_unlock_irqrestore(&chip->gpio_lock[index], flags);
+}
+
+/**
+ * xgpio_irq_unmask - Write the specified signal of the GPIO device.
+ * @irq_data: per irq and chip data passed down to chip functions
+ */
+static void xgpio_irq_unmask(struct irq_data *irq_data)
+{
+ unsigned long flags;
+ struct xgpio_instance *chip = irq_data_get_irq_chip_data(irq_data);
+ u32 offset = irq_data->irq - chip->irq_base;
+ u32 temp;
+ s32 val;
+ int index = xgpio_index(chip, 0);
+
+ pr_debug("%s: Enable %d irq, irq_enable_mask 0x%x\n",
+ __func__, offset, chip->irq_enable);
+
+ /* Setup pin as input */
+ xgpio_dir_in(&chip->gc, offset);
+
+ spin_lock_irqsave(&chip->gpio_lock[index], flags);
+
+ chip->irq_enable |= BIT(offset);
+
+ if (chip->irq_enable) {
+ /* Enable per channel interrupt */
+ temp = xgpio_readreg(chip->regs + XGPIO_IPIER_OFFSET);
+ val = offset - (chip->gpio_width[0] - 1);
+ if (val > 0)
+ temp |= 2;
+ else
+ temp |= 1;
+ xgpio_writereg(chip->regs + XGPIO_IPIER_OFFSET, temp);
+
+ /* Enable global interrupts */
+ xgpio_writereg(chip->regs + XGPIO_GIER_OFFSET, XGPIO_GIER_IE);
+ }
+
+ spin_unlock_irqrestore(&chip->gpio_lock[index], flags);
+}
+
+/**
+ * xgpio_set_irq_type - Write the specified signal of the GPIO device.
+ * @irq_data: Per irq and chip data passed down to chip functions
+ * @type: Interrupt type that is to be set for the gpio pin
+ *
+ * Return:
+ * 0 if interrupt type is supported otherwise otherwise -EINVAL
+ */
+static int xgpio_set_irq_type(struct irq_data *irq_data, unsigned int type)
+{
+ /* Only rising edge case is supported now */
+ if (type & IRQ_TYPE_EDGE_RISING)
+ return 0;
+
+ return -EINVAL;
+}
+
+/* irq chip descriptor */
+static struct irq_chip xgpio_irqchip = {
+ .name = "xgpio",
+ .irq_mask = xgpio_irq_mask,
+ .irq_unmask = xgpio_irq_unmask,
+ .irq_set_type = xgpio_set_irq_type,
+};
+
+/**
+ * xgpio_to_irq - Find out gpio to Linux irq mapping
+ * @gc: Pointer to gpio_chip device structure.
+ * @offset: Gpio pin offset
+ *
+ * Return:
+ * irq number otherwise -EINVAL
+ */
+static int xgpio_to_irq(struct gpio_chip *gc, unsigned int offset)
+{
+ struct xgpio_instance *chip = gpiochip_get_data(gc);
+
+ return irq_find_mapping(chip->irq_domain, offset);
+}
+
+/**
+ * xgpio_irqhandler - Gpio interrupt service routine
+ * @desc: Pointer to interrupt description
+ */
+static void xgpio_irqhandler(struct irq_desc *desc)
+{
+ unsigned int irq = irq_desc_get_irq(desc);
+ struct xgpio_instance *chip = (struct xgpio_instance *)
+ irq_get_handler_data(irq);
+ struct irq_chip *irqchip = irq_desc_get_chip(desc);
+ u32 offset, status, channel = 1;
+ unsigned long val;
+
+ chained_irq_enter(irqchip, desc);
+
+ val = xgpio_readreg(chip->regs);
+ if (!val) {
+ channel = 2;
+ val = xgpio_readreg(chip->regs + XGPIO_CHANNEL_OFFSET);
+ val = val << chip->gpio_width[0];
+ }
+
+ /* Only rising edge is supported */
+ val &= chip->irq_enable;
+ for_each_set_bit(offset, &val, chip->gc.ngpio) {
+ generic_handle_irq(chip->irq_base + offset);
+ }
+
+ status = xgpio_readreg(chip->regs + XGPIO_IPISR_OFFSET);
+ xgpio_writereg(chip->regs + XGPIO_IPISR_OFFSET, channel);
+
+ chained_irq_exit(irqchip, desc);
+}
+
+static struct lock_class_key gpio_lock_class;
+static struct lock_class_key gpio_request_class;
+
+/**
+ * xgpio_irq_setup - Allocate irq for gpio and setup appropriate functions
+ * @np: Device node of the GPIO chip
+ * @chip: Pointer to private gpio channel structure
+ *
+ * Return:
+ * 0 if success, otherwise -1
+ */
+static int xgpio_irq_setup(struct device_node *np, struct xgpio_instance *chip)
+{
+ u32 pin_num;
+ struct resource res;
+ int ret = of_irq_to_resource(np, 0, &res);
+
+ if (ret <= 0) {
+ pr_info("GPIO IRQ not connected\n");
+ return 0;
+ }
+
+ chip->gc.to_irq = xgpio_to_irq;
+ chip->irq_base = irq_alloc_descs(-1, 0, chip->gc.ngpio, 0);
+ if (chip->irq_base < 0) {
+ pr_err("Couldn't allocate IRQ numbers\n");
+ return -1;
+ }
+ chip->irq_domain = irq_domain_add_legacy(np, chip->gc.ngpio,
+ chip->irq_base, 0,
+ &irq_domain_simple_ops, NULL);
+ /*
+ * set the irq chip, handler and irq chip data for callbacks for
+ * each pin
+ */
+ for (pin_num = 0; pin_num < chip->gc.ngpio; pin_num++) {
+ u32 gpio_irq = irq_find_mapping(chip->irq_domain, pin_num);
+
+ irq_set_lockdep_class(gpio_irq, &gpio_lock_class,
+ &gpio_request_class);
+ pr_debug("IRQ Base: %d, Pin %d = IRQ %d\n",
+ chip->irq_base, pin_num, gpio_irq);
+ irq_set_chip_and_handler(gpio_irq, &xgpio_irqchip,
+ handle_simple_irq);
+ irq_set_chip_data(gpio_irq, (void *)chip);
+ }
+ irq_set_handler_data(res.start, (void *)chip);
+ irq_set_chained_handler(res.start, xgpio_irqhandler);
+
+ return 0;
+}
+
+/**
* xgpio_of_probe - Probe method for the GPIO device.
* @pdev: pointer to the platform device
*
@@ -434,6 +656,15 @@ static int xgpio_probe(struct platform_device *pdev)
goto err_pm_put;
}

+ status = xgpio_irq_setup(np, chip);
+ if (status) {
+ pr_err("%s: GPIO IRQ initialization failed %d\n",
+ np->full_name, status);
+ goto err_pm_put;
+ }
+ pr_info("XGpio: %s: registered, base is %d\n", np->full_name,
+ chip->gc.base);
+
pm_runtime_put(&pdev->dev);
return 0;
err_pm_put:
--
2.7.4
\
 
 \ /
  Last update: 2020-02-17 11:58    [W:0.086 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site