Messages in this thread | | | Date | Thu, 13 Feb 2020 10:15:46 +0800 | From | Shawn Guo <> | Subject | Re: [PATCH] ARM: dts: imx6dl-yapp4: Specify USB overcurrent protection polarity |
| |
On Wed, Jan 15, 2020 at 04:17:28PM +0100, Michal Vokáč wrote: > After reset the oc protection polarity is set to active high on imx6. > If the polarity is not specified in device tree it is not changed. > > The imx6dl-yapp4 platform uses an active-low oc signal so explicitly > configure that in the device tree. > > Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com>
Applied, thanks.
| |