lkml.org 
[lkml]   [2020]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/3] Input: atmel_mxt_ts - support wakeup methods
From
Date
06.12.2020 18:20, Linus Walleij пишет:
> On Sat, Dec 5, 2020 at 6:48 AM Dmitry Osipenko <digetx@gmail.com> wrote:
>
>> According to datasheets, chips like mXT1386 have a WAKE line, it is used
>> to wake the chip up from deep sleep mode before communicating with it via
>> the I2C-compatible interface.
>>
>> If the WAKE line is connected to a GPIO line, the line must be asserted
>> 25 ms before the host attempts to communicate with the controller. If the
>> WAKE line is connected to the SCL pin, the controller will send a NACK on
>> the first attempt to address it, the host must then retry 25 ms later.
>>
>> Implement the wake-up methods in the driver. Touchscreen now works
>> properly on devices like Acer A500 tablet, fixing problems like this:
>>
>> atmel_mxt_ts 0-004c: __mxt_read_reg: i2c transfer failed (-121)
>> atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121)
>> atmel_mxt_ts 0-004c: Trying alternate bootloader address
>> atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121)
>> atmel_mxt_ts: probe of 0-004c failed with error -121
>>
>> Signed-off-by: Jiada Wang <jiada_wang@mentor.com>
>> Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
>
> OK looks interesting!
>
>> + /* Request the WAKE line as asserted so controller won't sleep */
>> + data->wake_gpio = devm_gpiod_get_optional(&client->dev,
>> + "wake", GPIOD_OUT_HIGH);
>> + if (IS_ERR(data->wake_gpio)) {
>> + error = PTR_ERR(data->wake_gpio);
>> + dev_err(&client->dev, "Failed to get wake gpio: %d\n", error);
>> + return error;
>> + }
>
> That is a bit brutal, don't you think? Now you force the controller
> to be on at all times. Even across suspend/resume.

Still it's better than a disfunctional hardware :)

> Shouldn't the same patch drive this low in mxt_suspend()
> and driver it high + wait 25 ms in mxt_resume()?
> Waiting 25ms in mxt_resume() is chill, it is anyway on the
> slowpath.

I don't have hardware which uses the wake-gpio in order to test that it
works properly, hence wanted to keep it minimal. But indeed sounds like
toggling the GPIO in suspend/resume should be okay to do. Alright, I'll
improve it in the v3. Thank you!

\
 
 \ /
  Last update: 2020-12-06 20:46    [W:0.045 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site