lkml.org 
[lkml]   [2020]   [Dec]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/4] mfd: qca639x: add support for QCA639x powerup sequence
On Mon, Dec 21, 2020 at 05:08:44PM +0300, Dmitry Baryshkov wrote:
> Hello,
>
> On Mon, 21 Dec 2020 at 12:02, Lee Jones <lee.jones@linaro.org> wrote:
> >
> > On Sun, 20 Dec 2020, Dmitry Baryshkov wrote:
> >
> > > Qualcomm QCA639x is a family of WiFi + Bluetooth SoCs, with BT part
> > > being controlled through the UART and WiFi being present on PCIe
> > > bus. Both blocks share common power sources. So add mfd device driver
> > > handling power sequencing of QCA6390/1.
> > >
> > > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> > > ---
> > > drivers/mfd/Kconfig | 12 +++
> > > drivers/mfd/Makefile | 1 +
> > > drivers/mfd/qcom-qca639x.c | 168 +++++++++++++++++++++++++++++++++++++
> > > 3 files changed, 181 insertions(+)
> > > create mode 100644 drivers/mfd/qcom-qca639x.c
> >
> > This is not an MFD, since it utilised neither the MFD API nor
> > of_platform_populate() to register child devices.
>
> It would use them if the WiFi part was not on a discoverable bus.

PCI nodes have been supported in DT for forever. If you have
non-discoverable additions to a PCI device, then the PCI device should
be in DT.

Rob

\
 
 \ /
  Last update: 2020-12-31 23:54    [W:0.079 / U:0.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site