lkml.org 
[lkml]   [2020]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] riscv: add BUILTIN_DTB support for MMU-enabled targets
On Mon, Dec 28, 2020 at 3:10 PM Anup Patel <anup@brainfault.org> wrote:
>
> On Mon, Dec 28, 2020 at 7:05 PM Vitaly Wool <vitaly.wool@konsulko.com> wrote:
> >
> > On Mon, Dec 28, 2020 at 12:59 PM Anup Patel <anup@brainfault.org> wrote:
> > >
> > > On Sat, Dec 26, 2020 at 10:03 PM Vitaly Wool <vitaly.wool@konsulko.com> wrote:
> > > >
> > > > Sometimes, especially in a production system we may not want to
> > > > use a "smart bootloader" like u-boot to load kernel, ramdisk and
> > > > device tree from a filesystem on eMMC, but rather load the kernel
> > > > from a NAND partition and just run it as soon as we can, and in
> > > > this case it is convenient to have device tree compiled into the
> > > > kernel binary. Since this case is not limited to MMU-less systems,
> > > > let's support it for these which have MMU enabled too.
> > > >
> > > > Signed-off-by: Vitaly Wool <vitaly.wool@konsulko.com>
> > > > ---
> > > > arch/riscv/Kconfig | 1 -
> > > > arch/riscv/mm/init.c | 12 ++++++++++--
> > > > 2 files changed, 10 insertions(+), 3 deletions(-)
> > > >
> > > > diff --git a/arch/riscv/Kconfig b/arch/riscv/Kconfig
> > > > index 2b41f6d8e458..9464b4e3a71a 100644
> > > > --- a/arch/riscv/Kconfig
> > > > +++ b/arch/riscv/Kconfig
> > > > @@ -419,7 +419,6 @@ endmenu
> > > >
> > > > config BUILTIN_DTB
> > > > def_bool n
> > > > - depends on RISCV_M_MODE
> > > > depends on OF
> > > >
> > > > menu "Power management options"
> > > > diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
> > > > index 87c305c566ac..5d1c7a3ec01c 100644
> > > > --- a/arch/riscv/mm/init.c
> > > > +++ b/arch/riscv/mm/init.c
> > > > @@ -194,12 +194,20 @@ void __init setup_bootmem(void)
> > > > setup_initrd();
> > > > #endif /* CONFIG_BLK_DEV_INITRD */
> > > >
> > > > + /*
> > > > + * If DTB is built in, no need to reserve its memblock.
> > > > + * OTOH, initial_boot_params has to be set to properly copy DTB
> > > > + * before unflattening later on.
> > > > + */
> > > > + if (IS_ENABLED(CONFIG_BUILTIN_DTB))
> > > > + initial_boot_params = __va(dtb_early_pa);
> > >
> > > Don't assign initial_boot_params directly here because the
> > > early_init_dt_scan() will do it.
> >
> > early_init_dt_scan will set initial_boot_params to dtb_early_va from
> > the early mapping which will be gone by the time
> > unflatten_and_copy_device_tree() is called.
>
> That's why we are doing early_init_dt_verify() again for the MMU-enabled
> case which already takes care of your concern.

I might be out in the woods here but... Do you mean the call to
early_init_dt_verify() in setup_arch() which is compiled out
completely in the CONFIG_BUILTIN_DTB case?
Or is there any other call that I'm overlooking?

Best regards,
Vitaly

> We use early_init_dt_verify() like most architectures to set the initial DTB.
>
> >
> > > The setup_vm() is supposed to setup dtb_early_va and dtb_early_pa
> > > for MMU-enabled case so please add a "#ifdef" over there for the
> > > built-in DTB case.
> > >
> > > > + else
> > > > + memblock_reserve(dtb_early_pa, fdt_totalsize(dtb_early_va));
> > > > +
> > > > /*
> > > > * Avoid using early_init_fdt_reserve_self() since __pa() does
> > > > * not work for DTB pointers that are fixmap addresses
> > > > */
> > >
> > > This comment needs to be updated and moved along the memblock_reserve()
> > > statement.
> > >
> > > > - memblock_reserve(dtb_early_pa, fdt_totalsize(dtb_early_va));
> > > > -
> > > > early_init_fdt_scan_reserved_mem();
> > > > dma_contiguous_reserve(dma32_phys_limit);
> > > > memblock_allow_resize();
> > > > --
> > > > 2.29.2
> > > >
> > >
> > > This patch should be based upon Damiens builtin DTB patch.
> > > Refer, https://www.spinics.net/lists/linux-gpio/msg56616.html
> >
> > Thanks for the pointer, however I don't think our patches have
> > intersections. Besides, Damien is dealing with the MMU-less case
> > there.
>
> Damien's patch is also trying to move to use generic BUILTIN_DTB
> support for the MMU-less case so it is similar work hence the chance
> of patch conflict.
>
> Regards,
> Anup

\
 
 \ /
  Last update: 2020-12-28 17:41    [W:0.071 / U:1.248 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site