lkml.org 
[lkml]   [2020]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v1 1/2] dt-bindings: drm/bridge: anx7625: add DPI flag and swing setting
Hi Xin Ji,

Thank you for the patch.

On Fri, Dec 25, 2020 at 07:01:09PM +0800, Xin Ji wrote:
> Add DPI flag for distinguish MIPI input signal type, DSI or DPI. Add
> swing setting for adjusting DP tx PHY swing
>
> Signed-off-by: Xin Ji <xji@analogixsemi.com>
> ---
> .../bindings/display/bridge/analogix,anx7625.yaml | 19 +++++++++++++++++++
> 1 file changed, 19 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml b/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml
> index 60585a4..34a7faf 100644
> --- a/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml
> +++ b/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml
> @@ -34,6 +34,14 @@ properties:
> description: used for reset chip control, RESET_N pin B7.
> maxItems: 1
>
> + anx,swing-setting:
> + $ref: /schemas/types.yaml#/definitions/uint32-array
> + description: an array of swing register setting for DP tx PHY

Register values in DT are frowned upon.

> + anx,mipi-dpi-in:
> + $ref: /schemas/types.yaml#/definitions/uint32
> + description: indicate the MIPI rx signal type is DPI or DSI

This sounds similar to the bus-type property defined in
Documentation/devicetree/bindings/media/video-interfaces.txt (which is
getting converted to YAML, Rob has posted a patch series, I expect it to
land in v5.13). I think it would make sense to extend bus-type to
support DSI, and use that property.

> +
> ports:
> type: object
>
> @@ -72,6 +80,17 @@ examples:
> reg = <0x58>;
> enable-gpios = <&pio 45 GPIO_ACTIVE_HIGH>;
> reset-gpios = <&pio 73 GPIO_ACTIVE_HIGH>;
> + anx,swing-setting = <0x00 0x14>, <0x01 0x54>,
> + <0x02 0x64>, <0x03 0x74>, <0x04 0x29>,
> + <0x05 0x7b>, <0x06 0x77>, <0x07 0x5b>,
> + <0x08 0x7f>, <0x0c 0x20>, <0x0d 0x60>,
> + <0x10 0x60>, <0x12 0x40>, <0x13 0x60>,
> + <0x14 0x14>, <0x15 0x54>, <0x16 0x64>,
> + <0x17 0x74>, <0x18 0x29>, <0x19 0x7b>,
> + <0x1a 0x77>, <0x1b 0x5b>, <0x1c 0x7f>,
> + <0x20 0x20>, <0x21 0x60>, <0x24 0x60>,
> + <0x26 0x40>, <0x27 0x60>;
> + anx,mipi-dpi-in = <0>;
>
> ports {
> #address-cells = <1>;

--
Regards,

Laurent Pinchart

\
 
 \ /
  Last update: 2020-12-28 16:12    [W:0.119 / U:0.784 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site