lkml.org 
[lkml]   [2020]   [Dec]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 3/3] arm64: dts: sparx5: Add SGPIO devices
On Tue, Dec 22, 2020 at 11:09:41AM +0100, Lars Povlsen wrote:
>
> Andrew Lunn writes:
>
> > On Fri, Nov 13, 2020 at 03:51:51PM +0100, Lars Povlsen wrote:
> >> + led@8 {
> >> + label = "eth12:green";
> >> + gpios = <&sgpio_out0 12 0 GPIO_ACTIVE_HIGH>;
> >> + default-state = "off";
> >> + };
> >> + led@9 {
> >> + label = "eth12:yellow";
> >> + gpios = <&sgpio_out0 12 1 GPIO_ACTIVE_HIGH>;
> >> + default-state = "off";
> >> + };
> >
> > Hi Lars
> >
> > I did not see these patches earlier, but i've been looking at the
> > switch driver patches recently, so went digging.
> >
> > Can the Ethernet switch itself control these LEDs for indicating
> > things like packet receive/transmit, link state, and link speed? Or
> > are they purely software controlled?
> >
> > Thanks
> > Andrew
>
> Hi Andrew!
>
> No, the SGPIO device is separate from the switch device as such. I was
> planning to couple the two by means of "led events" in a later patch.

O.K, good.

In the LED subsystem terminology, such an event would be a
trigger. Link state, and copper speed should already be mostly covered
by phylib triggers. What is missing is link activity. Does the switch
easily provide you with this information, or do you need to poll the
switch statistics counters every 10ms to blink the LEDs?

Andrew

\
 
 \ /
  Last update: 2020-12-22 14:59    [W:0.063 / U:0.192 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site