lkml.org 
[lkml]   [2020]   [Dec]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v5 3/7] pwm: pca9685: Improve runtime PM behavior
Date
The chip does not come out of POR in active state but in sleep state.
To be sure (in case the bootloader woke it up) we force it to sleep in
probe.

On kernels without CONFIG_PM, we wake the chip in .probe and put it to
sleep in .remove.

Signed-off-by: Clemens Gruber <clemens.gruber@pqgruber.com>
---
drivers/pwm/pwm-pca9685.c | 20 ++++++++++++++++----
1 file changed, 16 insertions(+), 4 deletions(-)

diff --git a/drivers/pwm/pwm-pca9685.c b/drivers/pwm/pwm-pca9685.c
index b3398963c0ff..7b14447f3c05 100644
--- a/drivers/pwm/pwm-pca9685.c
+++ b/drivers/pwm/pwm-pca9685.c
@@ -467,14 +467,19 @@ static int pca9685_pwm_probe(struct i2c_client *client,
return ret;
}

- /* The chip comes out of power-up in the active state */
- pm_runtime_set_active(&client->dev);
/*
- * Enable will put the chip into suspend, which is what we
- * want as all outputs are disabled at this point
+ * The chip comes out of power-up in the sleep state,
+ * but force it to sleep in case it was woken up before
*/
+ pca9685_set_sleep_mode(pca, true);
+ pm_runtime_set_suspended(&client->dev);
pm_runtime_enable(&client->dev);

+ if (!IS_ENABLED(CONFIG_PM)) {
+ /* Wake the chip up on non-PM environments */
+ pca9685_set_sleep_mode(pca, false);
+ }
+
return 0;
}

@@ -486,7 +491,14 @@ static int pca9685_pwm_remove(struct i2c_client *client)
ret = pwmchip_remove(&pca->chip);
if (ret)
return ret;
+
pm_runtime_disable(&client->dev);
+
+ if (!IS_ENABLED(CONFIG_PM)) {
+ /* Put chip in sleep state on non-PM environments */
+ pca9685_set_sleep_mode(pca, true);
+ }
+
return 0;
}

--
2.29.2
\
 
 \ /
  Last update: 2020-12-15 22:29    [W:0.270 / U:0.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site