lkml.org 
[lkml]   [2020]   [Dec]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 19/21] arm64: dts: allwinner: Add Allwinner H616 .dtsi file
On Mon, 14 Dec 2020 10:58:31 +0100
Maxime Ripard <maxime@cerno.tech> wrote:

Hi,

> On Fri, Dec 11, 2020 at 01:19:32AM +0000, Andre Przywara wrote:
> > + reserved-memory {
> > + #address-cells = <2>;
> > + #size-cells = <2>;
> > + ranges;
> > +
> > + /* 512KiB reserved for ARM Trusted Firmware (BL31)
> > */
> > + secmon_reserved: secmon@40000000 {
> > + reg = <0x0 0x40000000 0x0 0x80000>;
> > + no-map;
> > + };
> > + };
>
> This should still be set by the firmware
>
> > + mmc0: mmc@4020000 {
> > + compatible = "allwinner,sun50i-h616-mmc",
> > + "allwinner,sun50i-a100-mmc";
> > + reg = <0x04020000 0x1000>;
> > + clocks = <&ccu CLK_BUS_MMC0>, <&ccu
> > CLK_MMC0>;
> > + clock-names = "ahb", "mmc";
> > + resets = <&ccu RST_BUS_MMC0>;
> > + reset-names = "ahb";
> > + interrupts = <GIC_SPI 35
> > IRQ_TYPE_LEVEL_HIGH>;
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&mmc0_pins>;
> > + status = "disabled";
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > + };
>
> Somewhat related: we shouldn't set the MMC speed flags in the drivers.
> This is biting us on the already supported SoCs, so it would be great
> to not repeat the same mistake with the new ones

Do you mean to list the "sd-uhs-sdr50" and friends properties here in
the DT?
What is the best practice here in terms putting them in the .dts vs.
the .dtsi? Surely the controller has limits, but bad traces on a board
could impose further restrictions, right?
Though that's probably rare, so it sounds like a lot of churn to list
them in every board DT. So can we list everything in here (.dtsi), then
delete in those affected boards only?

Cheers,
Andre

\
 
 \ /
  Last update: 2020-12-14 13:55    [W:0.082 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site