Messages in this thread Patch in this message | | | From | Chris Ruehl <> | Subject | [PATCH v2 1/2] devicetree: phy: rockchip-emmc optional add vendor prefix | Date | Tue, 15 Dec 2020 09:44:07 +0800 |
| |
Update the documentation and add the vendor prefix to the optional properties referred in vendor-prefixes.yaml. Follow up with commit 8b5c2b45b8f0a ("phy: rockchip: set pulldown for strobe line in dts") commit a8cef928276bb ("phy: rockchip-emmc: output tap delay dt property")
Signed-off-by: Chris Ruehl <chris.ruehl@gtsys.com.hk> --- .../devicetree/bindings/phy/rockchip-emmc-phy.txt | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt b/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt index 00aa2d349e55..57d28c0d5696 100644 --- a/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt +++ b/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt @@ -16,11 +16,11 @@ Optional properties: - drive-impedance-ohm: Specifies the drive impedance in Ohm. Possible values are 33, 40, 50, 66 and 100. If not set, the default value of 50 will be applied. - - enable-strobe-pulldown: Enable internal pull-down for the strobe line. - If not set, pull-down is not used. - - output-tapdelay-select: Specifies the phyctrl_otapdlysec register. - If not set, the register defaults to 0x4. - Maximum value 0xf. + - rockchip,enable-strobe-pulldown: Enable internal pull-down for the strobe + line. If not set, pull-down is not used. + - rockchip,output-tapdelay-select: Specifies the phyctrl_otapdlysec register. + If not set, the register defaults to 0x4. + Maximum value 0xf. Example: -- 2.20.1
| |