lkml.org 
[lkml]   [2020]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/2] ARM: dts: BCM5301X: Linksys EA9500 make use of pinctrl
From
Date


On 11/9/2020 5:24 AM, Vivek Unune wrote:
> On Wed, Nov 4, 2020 at 3:58 PM Vivek Unune <npcomplete13@gmail.com> wrote:
>>
>> On Wed, Nov 04, 2020 at 12:37:45PM -0800, Florian Fainelli wrote:
>>>
>>>
>>> On 11/4/2020 12:29 PM, Vivek Unune wrote:
>>>> Now that we have a pin controller, use that instead of manuplating the
>>>> mdio/mdc pins directly. i.e. we no longer require the mdio-mii-mux
>>>
>>> I am a bit confused here as I thought the mux was intended to
>>> dynamically switch the pins in order to support both internal and
>>> external MDIO devices but given the register ranges that were used,
>>> these were actually the pinmux configuration for the MDC and MDIO pins.
>>>
>>> This does not break USB and/or PCIe PHY communication does it?
>>
>> Hi Florian,
>>
>> The external and internal MDIO logic is controlled by mdio-bus-mux.
>> Which controls the BIT(9) of the mdio register. This stays.
>>
>> The removal of mdio-mii-mux and it's replacement with usage of
>> pinctrl doesn't affect USB3 or PCIe. See below USB3 detection.
>>
>> [ 4295.450118] usb 1-1: new high-speed USB device number 2 using ehci-platform
>> [ 4295.690183] usb 4-1: new SuperSpeed Gen 1 USB device number 2 using xhci-hcd
>> [ 4295.721888] usb-storage 4-1:1.0: USB Mass Storage device detected
>> [ 4295.728349] scsi host0: usb-storage 4-1:1.0
>> [ 4296.811047] scsi 0:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6
>> [ 4296.821159] sd 0:0:0:0: [sda] 60063744 512-byte logical blocks: (30.8 GB/28.6 GiB)
>> [ 4296.829667] sd 0:0:0:0: [sda] Write Protect is off
>> [ 4296.834502] sd 0:0:0:0: [sda] Mode Sense: 43 00 00 00
>> [ 4296.834864] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
>> [ 4296.852604] GPT:Primary header thinks Alt. header is not at the end of the disk.
>> [ 4296.860079] GPT:1540387 != 60063743
>> [ 4296.863586] GPT:Alternate GPT header not at the end of the disk.
>> [ 4296.869600] GPT:1540387 != 60063743
>> [ 4296.873090] GPT: Use GNU Parted to correct GPT errors.
>> [ 4296.878266] sda: sda1 sda2
>> [ 4296.884416] sd 0:0:0:0: [sda] Attached SCSI removable disk
>>
>
> Hi Florian,
>
> Does this clarify your confusion?

It does, thank you for bearing with me, I will apply this later today.
--
Florian

\
 
 \ /
  Last update: 2020-11-09 16:55    [W:0.072 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site