lkml.org 
[lkml]   [2020]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/8] cppc_cpufreq: simplify use of performance capabilities
Date
The CPPC performance capabilities are used significantly throughout
the driver. Simplify the use of them by introducing a local pointer
"caps" to point to cpu_data->perf_caps, in functions that access
performance capabilities often.

Signed-off-by: Ionela Voinescu <ionela.voinescu@arm.com>
Cc: Rafael J. Wysocki <rjw@rjwysocki.net>
Cc: Viresh Kumar <viresh.kumar@linaro.org>
---
drivers/cpufreq/cppc_cpufreq.c | 40 +++++++++++++++++++---------------
1 file changed, 23 insertions(+), 17 deletions(-)

diff --git a/drivers/cpufreq/cppc_cpufreq.c b/drivers/cpufreq/cppc_cpufreq.c
index 317169453549..7cc9bd8568de 100644
--- a/drivers/cpufreq/cppc_cpufreq.c
+++ b/drivers/cpufreq/cppc_cpufreq.c
@@ -183,15 +183,16 @@ static int cppc_verify_policy(struct cpufreq_policy_data *policy)
static void cppc_cpufreq_stop_cpu(struct cpufreq_policy *policy)
{
struct cppc_cpudata *cpu_data = all_cpu_data[policy->cpu];
+ struct cppc_perf_caps *caps = &cpu_data->perf_caps;
unsigned int cpu = policy->cpu;
int ret;

- cpu_data->perf_ctrls.desired_perf = cpu_data->perf_caps.lowest_perf;
+ cpu_data->perf_ctrls.desired_perf = caps->lowest_perf;

ret = cppc_set_perf(cpu, &cpu_data->perf_ctrls);
if (ret)
pr_debug("Err setting perf value:%d on CPU:%d. ret:%d\n",
- cpu_data->perf_caps.lowest_perf, cpu, ret);
+ caps->lowest_perf, cpu, ret);
}

/*
@@ -240,11 +241,12 @@ static unsigned int cppc_cpufreq_get_transition_delay_us(unsigned int cpu)
static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
{
struct cppc_cpudata *cpu_data = all_cpu_data[policy->cpu];
+ struct cppc_perf_caps *caps = &cpu_data->perf_caps;
unsigned int cpu = policy->cpu;
int ret = 0;

cpu_data->cpu = cpu;
- ret = cppc_get_perf_caps(cpu, &cpu_data->perf_caps);
+ ret = cppc_get_perf_caps(cpu, caps);

if (ret) {
pr_debug("Err reading CPU%d perf capabilities. ret:%d\n",
@@ -253,23 +255,27 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
}

/* Convert the lowest and nominal freq from MHz to KHz */
- cpu_data->perf_caps.lowest_freq *= 1000;
- cpu_data->perf_caps.nominal_freq *= 1000;
+ caps->lowest_freq *= 1000;
+ caps->nominal_freq *= 1000;

/*
* Set min to lowest nonlinear perf to avoid any efficiency penalty (see
* Section 8.4.7.1.1.5 of ACPI 6.1 spec)
*/
- policy->min = cppc_cpufreq_perf_to_khz(cpu_data, cpu_data->perf_caps.lowest_nonlinear_perf);
- policy->max = cppc_cpufreq_perf_to_khz(cpu_data, cpu_data->perf_caps.nominal_perf);
+ policy->min = cppc_cpufreq_perf_to_khz(cpu_data,
+ caps->lowest_nonlinear_perf);
+ policy->max = cppc_cpufreq_perf_to_khz(cpu_data,
+ caps->nominal_perf);

/*
* Set cpuinfo.min_freq to Lowest to make the full range of performance
* available if userspace wants to use any perf between lowest & lowest
* nonlinear perf
*/
- policy->cpuinfo.min_freq = cppc_cpufreq_perf_to_khz(cpu_data, cpu_data->perf_caps.lowest_perf);
- policy->cpuinfo.max_freq = cppc_cpufreq_perf_to_khz(cpu_data, cpu_data->perf_caps.nominal_perf);
+ policy->cpuinfo.min_freq = cppc_cpufreq_perf_to_khz(cpu_data,
+ caps->lowest_perf);
+ policy->cpuinfo.max_freq = cppc_cpufreq_perf_to_khz(cpu_data,
+ caps->nominal_perf);

policy->transition_delay_us = cppc_cpufreq_get_transition_delay_us(cpu);
policy->shared_type = cpu_data->shared_type;
@@ -283,7 +289,7 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
if (unlikely(i == cpu))
continue;

- memcpy(&all_cpu_data[i]->perf_caps, &cpu_data->perf_caps,
+ memcpy(&all_cpu_data[i]->perf_caps, caps,
sizeof(cpu_data->perf_caps));
}
} else if (policy->shared_type == CPUFREQ_SHARED_TYPE_ALL) {
@@ -298,18 +304,17 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
* If 'highest_perf' is greater than 'nominal_perf', we assume CPU Boost
* is supported.
*/
- if (cpu_data->perf_caps.highest_perf > cpu_data->perf_caps.nominal_perf)
+ if (caps->highest_perf > caps->nominal_perf)
boost_supported = true;

/* Set policy->cur to max now. The governors will adjust later. */
- policy->cur = cppc_cpufreq_perf_to_khz(cpu_data,
- cpu_data->perf_caps.highest_perf);
- cpu_data->perf_ctrls.desired_perf = cpu_data->perf_caps.highest_perf;
+ policy->cur = cppc_cpufreq_perf_to_khz(cpu_data, caps->highest_perf);
+ cpu_data->perf_ctrls.desired_perf = caps->highest_perf;

ret = cppc_set_perf(cpu, &cpu_data->perf_ctrls);
if (ret)
pr_debug("Err setting perf value:%d on CPU:%d. ret:%d\n",
- cpu_data->perf_caps.highest_perf, cpu, ret);
+ caps->highest_perf, cpu, ret);

return ret;
}
@@ -368,6 +373,7 @@ static unsigned int cppc_cpufreq_get_rate(unsigned int cpu)
static int cppc_cpufreq_set_boost(struct cpufreq_policy *policy, int state)
{
struct cppc_cpudata *cpu_data = all_cpu_data[policy->cpu];
+ struct cppc_perf_caps *caps = &cpu_data->perf_caps;
int ret;

if (!boost_supported) {
@@ -377,10 +383,10 @@ static int cppc_cpufreq_set_boost(struct cpufreq_policy *policy, int state)

if (state)
policy->max = cppc_cpufreq_perf_to_khz(cpu_data,
- cpu_data->perf_caps.highest_perf);
+ caps->highest_perf);
else
policy->max = cppc_cpufreq_perf_to_khz(cpu_data,
- cpu_data->perf_caps.nominal_perf);
+ caps->nominal_perf);
policy->cpuinfo.max_freq = policy->max;

ret = freq_qos_update_request(policy->max_freq_req, policy->max);
--
2.17.1
\
 
 \ /
  Last update: 2020-11-05 13:57    [W:0.162 / U:0.356 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site