lkml.org 
[lkml]   [2020]   [Nov]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 36/47] memory: tegra20-emc: Add devfreq support
From
Date
On 11/5/20 1:49 AM, Dmitry Osipenko wrote:
> Add devfreq support to the Tegra20 EMC driver. Memory utilization
> statistics will be periodically polled from the memory controller and
> appropriate minimum clock rate will be selected by the devfreq governor.
>
> Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
> ---
> drivers/memory/tegra/Kconfig | 2 +
> drivers/memory/tegra/tegra20-emc.c | 92 ++++++++++++++++++++++++++++++
> 2 files changed, 94 insertions(+)
>
> diff --git a/drivers/memory/tegra/Kconfig b/drivers/memory/tegra/Kconfig
> index ac3dfe155505..76e9a3b10839 100644
> --- a/drivers/memory/tegra/Kconfig
> +++ b/drivers/memory/tegra/Kconfig
> @@ -12,6 +12,8 @@ config TEGRA20_EMC
> tristate "NVIDIA Tegra20 External Memory Controller driver"
> default y
> depends on TEGRA_MC && ARCH_TEGRA_2x_SOC
> + select DEVFREQ_GOV_SIMPLE_ONDEMAND
> + select PM_DEVFREQ
> select PM_OPP

nitpick. If you select PM_DEVFREQ, don't need to select 'PM_OPP'
bacause PM_DEVFREQ use OPP as mandatory with 'select PM_OPP' in Kconfig.


> help
> This driver is for the External Memory Controller (EMC) found on
> diff --git a/drivers/memory/tegra/tegra20-emc.c b/drivers/memory/tegra/tegra20-emc.c
> index 5e10aa97809f..9946b957bb01 100644
> --- a/drivers/memory/tegra/tegra20-emc.c
> +++ b/drivers/memory/tegra/tegra20-emc.c
> @@ -8,6 +8,7 @@
> #include <linux/clk.h>
> #include <linux/clk/tegra.h>
> #include <linux/debugfs.h>
> +#include <linux/devfreq.h>
> #include <linux/err.h>
> #include <linux/interconnect-provider.h>
> #include <linux/interrupt.h>
> @@ -102,6 +103,10 @@
>
> #define EMC_FBIO_CFG5_DRAM_WIDTH_X16 BIT(4)
>
> +#define EMC_PWR_GATHER_CLEAR (1 << 8)
> +#define EMC_PWR_GATHER_DISABLE (2 << 8)
> +#define EMC_PWR_GATHER_ENABLE (3 << 8)
> +
> static const u16 emc_timing_registers[] = {
> EMC_RC,
> EMC_RFC,
> @@ -157,6 +162,7 @@ struct emc_timing {
> };
>
> enum emc_rate_request_type {
> + EMC_RATE_DEVFREQ,
> EMC_RATE_DEBUG,
> EMC_RATE_ICC,
> EMC_RATE_TYPE_MAX,
> @@ -193,6 +199,9 @@ struct tegra_emc {
>
> /* protect shared rate-change code path */
> struct mutex rate_lock;
> +
> + struct devfreq_simple_ondemand_data ondemand_data;
> + struct devfreq *devfreq;
> };
>
> static irqreturn_t tegra_emc_isr(int irq, void *data)
> @@ -952,6 +961,88 @@ static int tegra_emc_opp_table_init(struct tegra_emc *emc)
> return err;
> }
>
> +static int tegra_emc_devfreq_target(struct device *dev, unsigned long *freq,
> + u32 flags)
> +{
> + struct tegra_emc *emc = dev_get_drvdata(dev);
> + struct dev_pm_opp *opp;
> + unsigned long rate;
> +
> + opp = devfreq_recommended_opp(dev, freq, flags);
> + if (IS_ERR(opp)) {
> + dev_err(dev, "failed to find opp for %lu Hz\n", *freq);
> + return PTR_ERR(opp);
> + }
> +
> + rate = dev_pm_opp_get_freq(opp);
> + dev_pm_opp_put(opp);
> +
> + return emc_set_min_rate(emc, rate, EMC_RATE_DEVFREQ);
> +}
> +
> +static int tegra_emc_devfreq_get_dev_status(struct device *dev,
> + struct devfreq_dev_status *stat)
> +{
> + struct tegra_emc *emc = dev_get_drvdata(dev);
> +
> + /* freeze counters */
> + writel_relaxed(EMC_PWR_GATHER_DISABLE, emc->regs + EMC_STAT_CONTROL);
> +
> + /*
> + * busy_time: number of clocks EMC request was accepted
> + * total_time: number of clocks PWR_GATHER control was set to ENABLE
> + */
> + stat->busy_time = readl_relaxed(emc->regs + EMC_STAT_PWR_COUNT);
> + stat->total_time = readl_relaxed(emc->regs + EMC_STAT_PWR_CLOCKS);
> + stat->current_frequency = clk_get_rate(emc->clk);
> +
> + /* clear counters and restart */
> + writel_relaxed(EMC_PWR_GATHER_CLEAR, emc->regs + EMC_STAT_CONTROL);
> + writel_relaxed(EMC_PWR_GATHER_ENABLE, emc->regs + EMC_STAT_CONTROL);
> +
> + return 0;
> +}
> +
> +static struct devfreq_dev_profile tegra_emc_devfreq_profile = {
> + .polling_ms = 30,
> + .target = tegra_emc_devfreq_target,
> + .get_dev_status = tegra_emc_devfreq_get_dev_status,
> +};
> +
> +static int tegra_emc_devfreq_init(struct tegra_emc *emc)
> +{
> + int err;
> +
> + /*
> + * PWR_COUNT is 1/2 of PWR_CLOCKS at max, and thus, the up-threshold
> + * should be less than 50. Secondly, multiple active memory clients
> + * may cause over 20% of lost clock cycles due to stalls caused by
> + * competing memory accesses. This means that threshold should be
> + * set to a less than 30 in order to have a properly working governor.
> + */
> + emc->ondemand_data.upthreshold = 20;
> +
> + /*
> + * Reset statistic gathers state, select global bandwidth for the
> + * statistics collection mode and set clocks counter saturation
> + * limit to maximum.
> + */
> + writel_relaxed(0x00000000, emc->regs + EMC_STAT_CONTROL);
> + writel_relaxed(0x00000000, emc->regs + EMC_STAT_LLMC_CONTROL);
> + writel_relaxed(0xffffffff, emc->regs + EMC_STAT_PWR_CLOCK_LIMIT);
> +
> + emc->devfreq = devfreq_add_device(emc->dev, &tegra_emc_devfreq_profile,
> + DEVFREQ_GOV_SIMPLE_ONDEMAND,
> + &emc->ondemand_data);

Do you want to use 'devfreq_add_device' instead of
'devm_devfreq_add_device()'? If you have to use 'devfreq_add_device'
due to some reason, you need to call 'devfreq_remove_device' on exit.

> + if (IS_ERR(emc->devfreq)) {
> + err = PTR_ERR(emc->devfreq);
> + dev_err(emc->dev, "failed to initialize devfreq: %d", err);
> + return err;
> + }
> +
> + return 0;
> +}
> +
> static int tegra_emc_probe(struct platform_device *pdev)
> {
> struct device_node *np;
> @@ -1019,6 +1110,7 @@ static int tegra_emc_probe(struct platform_device *pdev)
> tegra_emc_rate_requests_init(emc);
> tegra_emc_debugfs_init(emc);
> tegra_emc_interconnect_init(emc);
> + tegra_emc_devfreq_init(emc);
>
> /*
> * Don't allow the kernel module to be unloaded. Unloading adds some
>


--
Best Regards,
Chanwoo Choi
Samsung Electronics

\
 
 \ /
  Last update: 2020-11-05 03:18    [W:0.870 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site