lkml.org 
[lkml]   [2020]   [Nov]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v10 00/19] Introduce memory interconnect for NVIDIA Tegra SoCs
From
Date
Hi Dmitry,

The v5.10-rc6 was released from linus git tree.
Generally, I will send the pull-quest about devfreq to linux-pm.git maintainer
after releasing the v5.1-rc7 for the integration test on linux-pm.git.

The icc patches in this patch have not yet merged. If these patches
are not merged before v5.10-rc7, Maybe, I'll apply the devfreq patches
for v5.12-rc1.

Best Regards,
Chanwoo Choi


On 11/23/20 9:27 AM, Dmitry Osipenko wrote:
> This series brings initial support for memory interconnect to Tegra20,
> Tegra30 and Tegra124 SoCs.
>
> For the starter only display controllers and devfreq devices are getting
> interconnect API support, others could be supported later on. The display
> controllers have the biggest demand for interconnect API right now because
> dynamic memory frequency scaling can't be done safely without taking into
> account bandwidth requirement from the displays. In particular this series
> fixes distorted display output on T30 Ouya and T124 TK1 devices.
>
> Changelog:
>
> v10 - In a longer run it will be much nicer if we could support EMC
> hardware versioning on Tegra20 and it's not late to support it now.
> Hence I added these new patches:
>
> dt-bindings: memory: tegra20: emc: Document opp-supported-hw property
> memory: tegra20: Support hardware versioning and clean up OPP table initialization
>
> - Removed error message from tegra30-devfreq driver about missing OPP
> properties in a device-tree because EMC driver already prints that
> message and it uses OPP API error code instead of checking DT directly,
> which is a more correct way of doing that.
>
> v9: - Squashed "memory: tegra30-emc: Factor out clk initialization" into
> patch "tegra30: Support interconnect framework".
> Suggested by Krzysztof Kozlowski.
>
> - Improved Kconfig in the patch "memory: tegra124-emc: Make driver modular"
> by adding CONFIG_TEGRA124_CLK_EMC entry, which makes clk-driver changes
> to look a bit more cleaner. Suggested by Krzysztof Kozlowski.
>
> - Dropped voltage regulator support from ICC and DT patches for now
> because there is a new discussion about using a power domain abstraction
> for controlling the regulator, which is likely to happen.
>
> - Replaced direct "operating-points-v2" property checking in EMC drivers
> with checking of a returned error code from dev_pm_opp_of_add_table().
> Note that I haven't touched T20 EMC driver because it's very likely
> that we'll replace that code with a common helper soon anyways.
> Suggested by Viresh Kumar.
>
> - The T30 DT patches now include EMC OPP changes for Ouya board, which
> is available now in linux-next.
>
> Dmitry Osipenko (19):
> dt-bindings: memory: tegra20: emc: Document opp-supported-hw property
> memory: tegra20: Support hardware versioning and clean up OPP table
> initialization
> memory: tegra30: Support interconnect framework
> memory: tegra124-emc: Make driver modular
> memory: tegra124-emc: Continue probing if timings are missing in
> device-tree
> memory: tegra124: Support interconnect framework
> drm/tegra: dc: Support memory bandwidth management
> drm/tegra: dc: Extend debug stats with total number of events
> PM / devfreq: tegra30: Support interconnect and OPPs from device-tree
> PM / devfreq: tegra30: Separate configurations per-SoC generation
> PM / devfreq: tegra20: Deprecate in a favor of emc-stat based driver
> ARM: tegra: Correct EMC registers size in Tegra20 device-tree
> ARM: tegra: Add interconnect properties to Tegra20 device-tree
> ARM: tegra: Add interconnect properties to Tegra30 device-tree
> ARM: tegra: Add interconnect properties to Tegra124 device-tree
> ARM: tegra: Add nvidia,memory-controller phandle to Tegra20 EMC
> device-tree
> ARM: tegra: Add EMC OPP properties to Tegra20 device-trees
> ARM: tegra: Add EMC OPP and ICC properties to Tegra30 EMC and ACTMON
> device-tree nodes
> ARM: tegra: Add EMC OPP and ICC properties to Tegra124 EMC and ACTMON
> device-tree nodes
>
> .../memory-controllers/nvidia,tegra20-emc.txt | 6 +
> MAINTAINERS | 1 -
> arch/arm/boot/dts/tegra124-apalis-emc.dtsi | 8 +
> .../arm/boot/dts/tegra124-jetson-tk1-emc.dtsi | 8 +
> arch/arm/boot/dts/tegra124-nyan-big-emc.dtsi | 10 +
> .../arm/boot/dts/tegra124-nyan-blaze-emc.dtsi | 10 +
> .../boot/dts/tegra124-peripherals-opp.dtsi | 419 ++++++++++++++++++
> arch/arm/boot/dts/tegra124.dtsi | 31 ++
> .../boot/dts/tegra20-acer-a500-picasso.dts | 5 +
> arch/arm/boot/dts/tegra20-colibri.dtsi | 4 +
> arch/arm/boot/dts/tegra20-paz00.dts | 4 +
> .../arm/boot/dts/tegra20-peripherals-opp.dtsi | 109 +++++
> arch/arm/boot/dts/tegra20.dtsi | 33 +-
> ...30-asus-nexus7-grouper-memory-timings.dtsi | 12 +
> arch/arm/boot/dts/tegra30-ouya.dts | 8 +
> .../arm/boot/dts/tegra30-peripherals-opp.dtsi | 383 ++++++++++++++++
> arch/arm/boot/dts/tegra30.dtsi | 33 +-
> drivers/clk/tegra/Kconfig | 3 +
> drivers/clk/tegra/Makefile | 2 +-
> drivers/clk/tegra/clk-tegra124-emc.c | 41 +-
> drivers/clk/tegra/clk-tegra124.c | 26 +-
> drivers/clk/tegra/clk.h | 18 +-
> drivers/devfreq/Kconfig | 10 -
> drivers/devfreq/Makefile | 1 -
> drivers/devfreq/tegra20-devfreq.c | 210 ---------
> drivers/devfreq/tegra30-devfreq.c | 147 +++---
> drivers/gpu/drm/tegra/Kconfig | 1 +
> drivers/gpu/drm/tegra/dc.c | 359 +++++++++++++++
> drivers/gpu/drm/tegra/dc.h | 19 +
> drivers/gpu/drm/tegra/drm.c | 14 +
> drivers/gpu/drm/tegra/hub.c | 3 +
> drivers/gpu/drm/tegra/plane.c | 121 +++++
> drivers/gpu/drm/tegra/plane.h | 15 +
> drivers/memory/tegra/Kconfig | 5 +-
> drivers/memory/tegra/tegra124-emc.c | 377 ++++++++++++++--
> drivers/memory/tegra/tegra124.c | 82 +++-
> drivers/memory/tegra/tegra20-emc.c | 48 +-
> drivers/memory/tegra/tegra30-emc.c | 344 +++++++++++++-
> drivers/memory/tegra/tegra30.c | 173 +++++++-
> include/linux/clk/tegra.h | 8 +
> include/soc/tegra/emc.h | 16 -
> 41 files changed, 2725 insertions(+), 402 deletions(-)
> create mode 100644 arch/arm/boot/dts/tegra124-peripherals-opp.dtsi
> create mode 100644 arch/arm/boot/dts/tegra20-peripherals-opp.dtsi
> create mode 100644 arch/arm/boot/dts/tegra30-peripherals-opp.dtsi
> delete mode 100644 drivers/devfreq/tegra20-devfreq.c
> delete mode 100644 include/soc/tegra/emc.h
>

\
 
 \ /
  Last update: 2020-11-30 09:32    [W:0.304 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site