lkml.org 
[lkml]   [2020]   [Nov]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH NOT FOR MERGE v3 3/3] ARM: dts: sun8i: a83t: bananapi-m3: Enable MIPI CSI-2 with OV8865
Date
From: Kévin L'hôpital <kevin.lhopital@bootlin.com>

The Bananapi M3 supports a camera module which includes an OV8865 sensor
connected via the parallel CSI interface and an OV8865 sensor connected
via MIPI CSI-2.

The I2C2 bus is shared by the two sensors as well as the (active-low)
reset signal, but each sensor has it own shutdown line.

Signed-off-by: Kévin L'hôpital <kevin.lhopital@bootlin.com>
Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>
---
arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts | 95 ++++++++++++++++++++
1 file changed, 95 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts b/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts
index 431f70234d36..3cb75054889f 100644
--- a/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts
+++ b/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts
@@ -85,6 +85,30 @@ green {
};
};

+ reg_ov8865_avdd: ov8865-avdd {
+ compatible = "regulator-fixed";
+ regulator-name = "ov8865-avdd";
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ vin-supply = <&reg_dldo4>;
+ };
+
+ reg_ov8865_dovdd: ov8865-dovdd {
+ compatible = "regulator-fixed";
+ regulator-name = "ov8865-dovdd";
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ vin-supply = <&reg_dldo4>;
+ };
+
+ reg_ov8865_dvdd: ov8865-dvdd {
+ compatible = "regulator-fixed";
+ regulator-name = "ov8865-dvdd";
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ vin-supply = <&reg_eldo1>;
+ };
+
reg_usb1_vbus: reg-usb1-vbus {
compatible = "regulator-fixed";
regulator-name = "usb1-vbus";
@@ -115,6 +139,16 @@ &cpu100 {
cpu-supply = <&reg_dcdc3>;
};

+&csi {
+ status = "okay";
+};
+
+&csi_in_mipi_csi2_bridge {
+ csi_in_mipi_csi2: endpoint {
+ remote-endpoint = <&mipi_csi2_out_csi>;
+ };
+};
+
&de {
status = "okay";
};
@@ -147,6 +181,36 @@ hdmi_out_con: endpoint {
};
};

+&i2c2 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c2_pe_pins>;
+ status = "okay";
+
+ ov8865: camera@36 {
+ compatible = "ovti,ov8865";
+ reg = <0x36>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&csi_mclk_pin>;
+ clocks = <&ccu CLK_CSI_MCLK>;
+ assigned-clocks = <&ccu CLK_CSI_MCLK>;
+ assigned-clock-rates = <24000000>;
+ avdd-supply = <&reg_ov8865_avdd>;
+ dovdd-supply = <&reg_ov8865_dovdd>;
+ dvdd-supply = <&reg_ov8865_dvdd>;
+ powerdown-gpios = <&pio 4 17 GPIO_ACTIVE_LOW>; /* PE17 */
+ reset-gpios = <&pio 4 16 GPIO_ACTIVE_LOW>; /* PE16 */
+
+ port {
+ ov8865_out_mipi_csi2: endpoint {
+ data-lanes = <1 2 3 4>;
+ link-frequencies = /bits/ 64 <360000000>;
+
+ remote-endpoint = <&mipi_csi2_in_ov8865>;
+ };
+ };
+ };
+};
+
&mdio {
rgmii_phy: ethernet-phy@1 {
compatible = "ethernet-phy-ieee802.3-c22";
@@ -154,6 +218,24 @@ rgmii_phy: ethernet-phy@1 {
};
};

+&mipi_csi2 {
+ status = "okay";
+};
+
+&mipi_csi2_in {
+ mipi_csi2_in_ov8865: endpoint {
+ data-lanes = <1 2 3 4>;
+
+ remote-endpoint = <&ov8865_out_mipi_csi2>;
+ };
+};
+
+&mipi_csi2_out {
+ mipi_csi2_out_csi: endpoint {
+ remote-endpoint = <&csi_in_mipi_csi2>;
+ };
+};
+
&mmc0 {
pinctrl-names = "default";
pinctrl-0 = <&mmc0_pins>;
@@ -327,11 +409,24 @@ &reg_dldo3 {
regulator-name = "vcc-pd";
};

+&reg_dldo4 {
+ regulator-always-on;
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ regulator-name = "avdd-csi";
+};
+
&reg_drivevbus {
regulator-name = "usb0-vbus";
status = "okay";
};

+&reg_eldo1 {
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ regulator-name = "dvdd-csi-r";
+};
+
&reg_fldo1 {
regulator-min-microvolt = <1080000>;
regulator-max-microvolt = <1320000>;
--
2.29.2
\
 
 \ /
  Last update: 2020-11-28 23:39    [W:0.064 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site