lkml.org 
[lkml]   [2020]   [Nov]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 2/3] net: sparx5: Add Sparx5 switchdev driver
On Sat, Nov 28, 2020 at 08:06:16PM +0100, Andrew Lunn wrote:
> > +static void sparx5_phylink_mac_config(struct phylink_config *config,
> > + unsigned int mode,
> > + const struct phylink_link_state *state)
> > +{
> > + struct sparx5_port *port = netdev_priv(to_net_dev(config->dev));
> > + struct sparx5_port_config conf;
> > + int err = 0;
> > +
> > + conf = port->conf;
> > + conf.autoneg = state->an_enabled;
> > + conf.pause = state->pause;
> > + conf.duplex = state->duplex;
> > + conf.power_down = false;
> > + conf.portmode = state->interface;
> > +
> > + if (state->speed == SPEED_UNKNOWN) {
> > + /* When a SFP is plugged in we use capabilities to
> > + * default to the highest supported speed
> > + */
>
> This looks suspicious.

Yes, it looks highly suspicious. The fact that
sparx5_phylink_mac_link_up() is empty, and sparx5_phylink_mac_config()
does all the work suggests that this was developed before the phylink
re-organisation, and this code hasn't been updated for it.

Any new code for the kernel really ought to be updated for the new
phylink methodology before it is accepted.

Looking at sparx5_port_config(), it also seems to use
PHY_INTERFACE_MODE_1000BASEX for both 1000BASE-X and 2500BASE-X. All
very well for the driver to do that internally, but it's confusing
when it comes to reviewing this stuff, especially when people outside
of the driver (such as myself) reviewing it need to understand what's
going on with the configuration.

--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!

\
 
 \ /
  Last update: 2020-11-28 23:39    [W:0.196 / U:0.708 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site