lkml.org 
[lkml]   [2020]   [Nov]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/5] ACPI: EC: Fold acpi_ec_clear_gpe() into its caller
Date
From: "Rafael J. Wysocki" <rafael.j.wysocki@intel.com>

Fold acpi_ec_clear_gpe() which is only used in one place into its
caller and clean up comments related to that function while at it.

No intentional functional impact.

Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
---
drivers/acpi/ec.c | 35 +++++++++++++----------------------
1 file changed, 13 insertions(+), 22 deletions(-)

diff --git a/drivers/acpi/ec.c b/drivers/acpi/ec.c
index 0caf5ca1fc07..97e595238a8c 100644
--- a/drivers/acpi/ec.c
+++ b/drivers/acpi/ec.c
@@ -372,23 +372,6 @@ static inline void acpi_ec_disable_gpe(struct acpi_ec *ec, bool close)
}
}

-static inline void acpi_ec_clear_gpe(struct acpi_ec *ec)
-{
- /*
- * GPE STS is a W1C register, which means:
- * 1. Software can clear it without worrying about clearing other
- * GPEs' STS bits when the hardware sets them in parallel.
- * 2. As long as software can ensure only clearing it when it is
- * set, hardware won't set it in parallel.
- * So software can clear GPE in any contexts.
- * Warning: do not move the check into advance_transaction() as the
- * EC commands will be sent without GPE raised.
- */
- if (!acpi_ec_is_gpe_raised(ec))
- return;
- acpi_clear_gpe(NULL, ec->gpe);
-}
-
/* --------------------------------------------------------------------------
* Transaction Management
* -------------------------------------------------------------------------- */
@@ -639,13 +622,21 @@ static void advance_transaction(struct acpi_ec *ec, bool interrupt)
bool wakeup = false;

ec_dbg_stm("%s (%d)", interrupt ? "IRQ" : "TASK", smp_processor_id());
+
/*
- * By always clearing STS before handling all indications, we can
- * ensure a hardware STS 0->1 change after this clearing can always
- * trigger a GPE interrupt.
+ * Clear GPE_STS upfront to allow subsequent hardware GPE_STS 0->1
+ * changes to always trigger a GPE interrupt.
+ *
+ * GPE STS is a W1C register, which means:
+ *
+ * 1. Software can clear it without worrying about clearing the other
+ * GPEs' STS bits when the hardware sets them in parallel.
+ *
+ * 2. As long as software can ensure only clearing it when it is set,
+ * hardware won't set it in parallel.
*/
- if (ec->gpe >= 0)
- acpi_ec_clear_gpe(ec);
+ if (ec->gpe >= 0 && acpi_ec_is_gpe_raised(ec))
+ acpi_clear_gpe(NULL, ec->gpe);

status = acpi_ec_read_status(ec);
t = ec->curr;
--
2.26.2



\
 
 \ /
  Last update: 2020-11-23 20:44    [W:0.039 / U:0.328 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site