lkml.org 
[lkml]   [2020]   [Nov]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/6] phy: stm32: manage 1v1 and 1v8 supplies at pll activation/deactivation
Date
PLL block requires to be powered with 1v1 and 1v8 supplies to catch
ENABLE signal.
Currently, supplies are managed through phy_ops .power_on/off, and PLL
activation/deactivation is managed through phy_ops .init/exit.
The sequence of phy_ops .power_on/.phy_init, .power_off/.exit is USB
drivers dependent.
To ensure a good behavior of the PLL, supplies have to be managed at PLL
activation/deactivation. That means the supplies need to be put in usbphyc
node and not in phy children nodes.

Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
---
drivers/phy/st/phy-stm32-usbphyc.c | 102 +++++++++++++----------------
1 file changed, 46 insertions(+), 56 deletions(-)

diff --git a/drivers/phy/st/phy-stm32-usbphyc.c b/drivers/phy/st/phy-stm32-usbphyc.c
index a54317e96c41..c78a2c7947ce 100644
--- a/drivers/phy/st/phy-stm32-usbphyc.c
+++ b/drivers/phy/st/phy-stm32-usbphyc.c
@@ -58,7 +58,6 @@ struct pll_params {
struct stm32_usbphyc_phy {
struct phy *phy;
struct stm32_usbphyc *usbphyc;
- struct regulator_bulk_data supplies[NUM_SUPPLIES];
u32 index;
bool active;
};
@@ -70,6 +69,7 @@ struct stm32_usbphyc {
struct reset_control *rst;
struct stm32_usbphyc_phy **phys;
int nphys;
+ struct regulator_bulk_data supplies[NUM_SUPPLIES];
int switch_setup;
};

@@ -153,10 +153,30 @@ static bool stm32_usbphyc_has_one_phy_active(struct stm32_usbphyc *usbphyc)
return false;
}

+static int stm32_usbphyc_pll_disable(struct stm32_usbphyc *usbphyc)
+{
+ void __iomem *pll_reg = usbphyc->base + STM32_USBPHYC_PLL;
+
+ /* Check if other phy port active */
+ if (stm32_usbphyc_has_one_phy_active(usbphyc))
+ return 0;
+
+ stm32_usbphyc_clr_bits(pll_reg, PLLEN);
+ /* Wait for minimum width of powerdown pulse (ENABLE = Low) */
+ udelay(PLL_PWR_DOWN_TIME_US);
+
+ if (readl_relaxed(pll_reg) & PLLEN) {
+ dev_err(usbphyc->dev, "PLL not reset\n");
+ return -EIO;
+ }
+
+ return regulator_bulk_disable(NUM_SUPPLIES, usbphyc->supplies);
+}
+
static int stm32_usbphyc_pll_enable(struct stm32_usbphyc *usbphyc)
{
void __iomem *pll_reg = usbphyc->base + STM32_USBPHYC_PLL;
- bool pllen = (readl_relaxed(pll_reg) & PLLEN);
+ bool pllen = readl_relaxed(pll_reg) & PLLEN;
int ret;

/* Check if one phy port has already configured the pll */
@@ -164,46 +184,35 @@ static int stm32_usbphyc_pll_enable(struct stm32_usbphyc *usbphyc)
return 0;

if (pllen) {
- stm32_usbphyc_clr_bits(pll_reg, PLLEN);
- /* Wait for minimum width of powerdown pulse (ENABLE = Low) */
- udelay(PLL_PWR_DOWN_TIME_US);
+ ret = stm32_usbphyc_pll_disable(usbphyc);
+ if (ret)
+ return ret;
}

- ret = stm32_usbphyc_pll_init(usbphyc);
+ ret = regulator_bulk_enable(NUM_SUPPLIES, usbphyc->supplies);
if (ret)
return ret;

- stm32_usbphyc_set_bits(pll_reg, PLLEN);
+ ret = stm32_usbphyc_pll_init(usbphyc);
+ if (ret)
+ goto reg_disable;

+ stm32_usbphyc_set_bits(pll_reg, PLLEN);
/* Wait for maximum lock time */
udelay(PLL_LOCK_TIME_US);

if (!(readl_relaxed(pll_reg) & PLLEN)) {
dev_err(usbphyc->dev, "PLLEN not set\n");
- return -EIO;
+ ret = -EIO;
+ goto reg_disable;
}

return 0;
-}
-
-static int stm32_usbphyc_pll_disable(struct stm32_usbphyc *usbphyc)
-{
- void __iomem *pll_reg = usbphyc->base + STM32_USBPHYC_PLL;
-
- /* Check if other phy port active */
- if (stm32_usbphyc_has_one_phy_active(usbphyc))
- return 0;

- stm32_usbphyc_clr_bits(pll_reg, PLLEN);
- /* Wait for minimum width of powerdown pulse (ENABLE = Low) */
- udelay(PLL_PWR_DOWN_TIME_US);
+reg_disable:
+ regulator_bulk_disable(NUM_SUPPLIES, usbphyc->supplies);

- if (readl_relaxed(pll_reg) & PLLEN) {
- dev_err(usbphyc->dev, "PLL not reset\n");
- return -EIO;
- }
-
- return 0;
+ return ret;
}

static int stm32_usbphyc_phy_init(struct phy *phy)
@@ -231,25 +240,9 @@ static int stm32_usbphyc_phy_exit(struct phy *phy)
return stm32_usbphyc_pll_disable(usbphyc);
}

-static int stm32_usbphyc_phy_power_on(struct phy *phy)
-{
- struct stm32_usbphyc_phy *usbphyc_phy = phy_get_drvdata(phy);
-
- return regulator_bulk_enable(NUM_SUPPLIES, usbphyc_phy->supplies);
-}
-
-static int stm32_usbphyc_phy_power_off(struct phy *phy)
-{
- struct stm32_usbphyc_phy *usbphyc_phy = phy_get_drvdata(phy);
-
- return regulator_bulk_disable(NUM_SUPPLIES, usbphyc_phy->supplies);
-}
-
static const struct phy_ops stm32_usbphyc_phy_ops = {
.init = stm32_usbphyc_phy_init,
.exit = stm32_usbphyc_phy_exit,
- .power_on = stm32_usbphyc_phy_power_on,
- .power_off = stm32_usbphyc_phy_power_off,
.owner = THIS_MODULE,
};

@@ -313,7 +306,7 @@ static int stm32_usbphyc_probe(struct platform_device *pdev)
struct device_node *child, *np = dev->of_node;
struct phy_provider *phy_provider;
u32 version;
- int ret, port = 0;
+ int ret, i, port = 0;

usbphyc = devm_kzalloc(dev, sizeof(*usbphyc), GFP_KERNEL);
if (!usbphyc)
@@ -355,11 +348,20 @@ static int stm32_usbphyc_probe(struct platform_device *pdev)
goto clk_disable;
}

+ for (i = 0; i < NUM_SUPPLIES; i++)
+ usbphyc->supplies[i].supply = supplies_names[i];
+
+ ret = devm_regulator_bulk_get(dev, NUM_SUPPLIES, usbphyc->supplies);
+ if (ret) {
+ if (ret != -EPROBE_DEFER)
+ dev_err(dev, "failed to get regulators: %d\n", ret);
+ goto clk_disable;
+ }
+
for_each_child_of_node(np, child) {
struct stm32_usbphyc_phy *usbphyc_phy;
struct phy *phy;
u32 index;
- int i;

phy = devm_phy_create(dev, child, &stm32_usbphyc_phy_ops);
if (IS_ERR(phy)) {
@@ -377,18 +379,6 @@ static int stm32_usbphyc_probe(struct platform_device *pdev)
goto put_child;
}

- for (i = 0; i < NUM_SUPPLIES; i++)
- usbphyc_phy->supplies[i].supply = supplies_names[i];
-
- ret = devm_regulator_bulk_get(&phy->dev, NUM_SUPPLIES,
- usbphyc_phy->supplies);
- if (ret) {
- if (ret != -EPROBE_DEFER)
- dev_err(&phy->dev,
- "failed to get regulators: %d\n", ret);
- goto put_child;
- }
-
ret = of_property_read_u32(child, "reg", &index);
if (ret || index > usbphyc->nphys) {
dev_err(&phy->dev, "invalid reg property: %d\n", ret);
--
2.17.1
\
 
 \ /
  Last update: 2020-11-23 18:06    [W:1.372 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site