lkml.org 
[lkml]   [2020]   [Nov]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 1/3] pwm: pca9685: Switch to atomic API
On Thu, Nov 19, 2020 at 5:00 AM Clemens Gruber
<clemens.gruber@pqgruber.com> wrote:
>
> > You appear to mix cached and uncached uses of prescale,
> > is there a need for this? If not, perhaps pick one and use
> > it consistently?
>
> Yes, sticking to the cached value is probably the way to go.
>

I would suggest going one step further, and turn on the cache in
regmap, i.e. .cache_type = REGCACHE_RBTREE, then:
- no need to cache pca->prescale explicitly, you can just read it with
regmap_read() every time, and it won't result in bus activity.
then you can eliminate pca->prescale, which simplifies the driver.
- pca9685_pwm_get_state() no longer results in bus reads, every regmap_read()
is cached, this is extremely efficient.
- pca9685_pwm_apply() and pca9685_pwm_gpio_set() now only does bus writes if
registers actually change, i.e. calling pwm_apply() multiple times in a row
with the same parameters, writes the registers only once.

We can do this safely because this chip never actively writes to its
registers (as far as I know).

But maybe that's a suggestion for a follow-up patch...

> > Also, if the prescale register contains an invalid value
> > during probe(), e.g. 0x00 or 0x01, would it make sense
> > to explicitly overwrite it with a valid setting?
>
> As long as it is overwritten with a correct setting when the PWM is used
> for the first time, it should be OK?

I'm not sure. Consider the following scenario:
- prescale register is invalid at probe, say it contains 0x02
- user calls pwm_apply() but with an invalid period, which results
in a calculated prescale value of 0x02
- pca9685_pwm_apply() skips prescale setup because prescale does not
change, returns OK(0)
- user believes setup was ok, actually it's broken...

Also, some people use this chip exclusively as a gpiochip, in that
case the prescale register is never touched. So an invalid prescale
at probe is never corrected.

Speaking of the gpiochip side, would it make sense to call
pca9685_pwm_full_on()/_off() in pca9685_pwm_gpio_set() too?

\
 
 \ /
  Last update: 2020-11-19 16:00    [W:0.097 / U:0.576 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site