lkml.org 
[lkml]   [2020]   [Oct]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 1/2] net: phy: adin: disable diag clock & disable standby mode in config_aneg
On Sat, Oct 24, 2020 at 1:43 AM Andrew Lunn <andrew@lunn.ch> wrote:
>
> On Thu, Oct 22, 2020 at 10:45:50AM +0300, Alexandru Ardelean wrote:
> > When the PHY powers up, the diagnostics clock isn't enabled (bit 2 in
> > register PHY_CTRL_1 (0x0012)).
> > Also, the PHY is not in standby mode, so bit 13 in PHY_CTRL_3 (0x0017) is
> > always set at power up.
> >
> > The standby mode and the diagnostics clock are both meant to be for the
> > cable diagnostics feature of the PHY (in phylib this would be equivalent to
> > the cable-test support), and for the frame-generator feature of the PHY.
> >
> > In standby mode, the PHY doesn't negotiate links or manage links.
> >
> > To use the cable diagnostics/test (or frame-generator), the PHY must be
> > first set in standby mode, so that the link operation doesn't interfere.
> > Then, the diagnostics clock must be enabled.
> >
> > For the cable-test feature, when the operation finishes, the PHY goes into
> > PHY_UP state, and the config_aneg hook is called.
> >
> > For the ADIN PHY, we need to make sure that during autonegotiation
> > configuration/setup the PHY is removed from standby mode and the
> > diagnostics clock is disabled, so that normal operation is resumed.
> >
> > This change does that by moving the set of the ADIN1300_LINKING_EN bit (2)
> > in the config_aneg (to disable standby mode).
> > Previously, this was set in the downshift setup, because the downshift
> > retry value and the ADIN1300_LINKING_EN are in the same register.
> >
> > And the ADIN1300_DIAG_CLK_EN bit (13) is cleared, to disable the
> > diagnostics clock.
> >
> > Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
>
> Reviewed-by: Andrew Lunn <andrew@lunn.ch>

So, then re-send for this or just this patch ping?
Naturally, this is for net-next.
I don't mind doing either way.

Thanks
Alex

>
> Andrew

\
 
 \ /
  Last update: 2020-10-31 13:17    [W:0.078 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site