lkml.org 
[lkml]   [2020]   [Oct]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH RFC v3 4/4] Documentation/admin-guide: Change doc for split_lock_detect parameter
Date
Since #DB for bus lock detect changes the split_lock_detect parameter,
update the documentation for the changes.

Signed-off-by: Fenghua Yu <fenghua.yu@intel.com>
Reviewed-by: Tony Luck <tony.luck@intel.com>
---
Change Log:
- Simplify the documentation (Randy).

.../admin-guide/kernel-parameters.txt | 28 +++++++++++++++----
1 file changed, 23 insertions(+), 5 deletions(-)

diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt
index 526d65d8573a..ee419ce659f5 100644
--- a/Documentation/admin-guide/kernel-parameters.txt
+++ b/Documentation/admin-guide/kernel-parameters.txt
@@ -5044,27 +5044,45 @@
spia_peddr=

split_lock_detect=
- [X86] Enable split lock detection
+ [X86] Enable split lock detection or bus lock detection

When enabled (and if hardware support is present), atomic
instructions that access data across cache line
- boundaries will result in an alignment check exception.
+ boundaries will result in an alignment check exception
+ for split lock detection or a debug exception for
+ bus lock detection.

off - not enabled

warn - the kernel will emit rate limited warnings
about applications triggering the #AC
- exception. This mode is the default on CPUs
- that supports split lock detection.
+ exception or the #DB exception. This mode is
+ the default on CPUs that supports split lock
+ detection or bus lock detection. Default
+ behavior is from #DB if both features are
+ enabled in hardware.

fatal - the kernel will send SIGBUS to applications
- that trigger the #AC exception.
+ that trigger the #AC exception or the #DB
+ exception. Default behavior is from #AC
+ if both features are enabled in hardware.
+
+ ratelimit:N -
+ Set rate limit to N bus locks per second
+ for bus lock detection. 0 < N <= HZ/2 and
+ N is approximate. Only applied to non root
+ user.
+
+ N/A for split lock detection.

If an #AC exception is hit in the kernel or in
firmware (i.e. not while executing in user mode)
the kernel will oops in either "warn" or "fatal"
mode.

+ #DB exception for bus lock is triggered only when
+ CPL > 0.
+
srbds= [X86,INTEL]
Control the Special Register Buffer Data Sampling
(SRBDS) mitigation.
--
2.29.1
\
 
 \ /
  Last update: 2020-10-31 01:28    [W:0.057 / U:1.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site