Messages in this thread | | | From | Krzysztof Kozlowski <> | Date | Sat, 3 Oct 2020 12:13:54 +0200 | Subject | Re: [PATCH v2 3/4] ARM: dts: exynos: Add Ethernet to Artik 5 board |
| |
On Fri, 2 Oct 2020 at 21:22, Łukasz Stelmach <l.stelmach@samsung.com> wrote: > > Add node for ax88796c ethernet chip. > > Signed-off-by: Łukasz Stelmach <l.stelmach@samsung.com> > --- > arch/arm/boot/dts/exynos3250-artik5-eval.dts | 21 ++++++++++++++++++++ > 1 file changed, 21 insertions(+) > > diff --git a/arch/arm/boot/dts/exynos3250-artik5-eval.dts b/arch/arm/boot/dts/exynos3250-artik5-eval.dts > index 20446a846a98..7f115c348a2a 100644 > --- a/arch/arm/boot/dts/exynos3250-artik5-eval.dts > +++ b/arch/arm/boot/dts/exynos3250-artik5-eval.dts > @@ -37,3 +37,24 @@ &mshc_2 { > &serial_2 { > status = "okay"; > }; > + > +&spi_0 { > + status = "okay"; > + cs-gpios = <&gpx3 4 GPIO_ACTIVE_LOW>, <0>; > + > + assigned-clocks = <&cmu CLK_MOUT_MPLL>, <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>, <&cmu CLK_DIV_SPI0>, <&cmu CLK_DIV_SPI0_PRE>, <&cmu CLK_SCLK_SPI0>;
No spaces before or after '='.
> + assigned-clock-parents = <&cmu CLK_FOUT_MPLL>, <&cmu CLK_MOUT_MPLL>, <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>, <&cmu CLK_DIV_SPI0>, <&cmu CLK_DIV_SPI0_PRE>;
This line is still too long. Please wrap it at 80. Checkpatch should complain about it... so it seems you did not run it. Please fix all checkpatch issues.
> + > + ax88796c@0 { > + compatible = "asix,ax88796c"; > + local-mac-address = [00 00 00 00 00 00]; /* Filled in by a boot-loader */ > + interrupt-parent = <&gpx2>; > + interrupts = <0 IRQ_TYPE_LEVEL_LOW>; > + spi-max-frequency = <40000000>; > + reg = <0x0>;
Put reg after compatible.
Best regards, Krzysztof
| |