lkml.org 
[lkml]   [2020]   [Oct]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] watchdog: qcom_wdt: set WDOG_HW_RUNNING bit when appropriate
Date
From: Robert Marko <robimarko@gmail.com>

If the watchdog hardware is enabled/running during boot, e.g.
due to a boot loader configuring it, we must tell the
watchdog framework about this fact so that it can ping the
watchdog until userspace opens the device and takes over
control.

Do so using the WDOG_HW_RUNNING flag that exists for exactly
that use-case.

Given the watchdog driver core doesn't know what timeout was
originally set by whoever started the watchdog (boot loader),
we make sure to update the timeout in the hardware according
to what the watchdog core thinks it is.

Signed-off-by: Robert Marko <robimarko@gmail.com>
Cc: Luka Perkov <luka.perkov@sartura.hr>
---
drivers/watchdog/qcom-wdt.c | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)

diff --git a/drivers/watchdog/qcom-wdt.c b/drivers/watchdog/qcom-wdt.c
index eb47fe5ed280..546ac5b78869 100644
--- a/drivers/watchdog/qcom-wdt.c
+++ b/drivers/watchdog/qcom-wdt.c
@@ -147,6 +147,13 @@ static int qcom_wdt_restart(struct watchdog_device *wdd, unsigned long action,
return 0;
}

+static int qcom_wdt_is_running(struct watchdog_device *wdd)
+{
+ struct qcom_wdt *wdt = to_qcom_wdt(wdd);
+
+ return (readl(wdt_addr(wdt, WDT_EN)) & 1);
+}
+
static const struct watchdog_ops qcom_wdt_ops = {
.start = qcom_wdt_start,
.stop = qcom_wdt_stop,
@@ -280,6 +287,21 @@ static int qcom_wdt_probe(struct platform_device *pdev)
wdt->wdd.timeout = min(wdt->wdd.max_timeout, 30U);
watchdog_init_timeout(&wdt->wdd, 0, dev);

+ if (qcom_wdt_is_running(&wdt->wdd)) {
+ /*
+ * Make sure to apply timeout from watchdog core, taking
+ * the prescaler of this driver here into account (the
+ * boot loader might be using a different prescaler).
+ *
+ * To avoid spurious resets because of different scaling,
+ * we first disable the watchdog, set the new prescaler
+ * and timeout, and then re-enable the watchdog.
+ */
+ qcom_wdt_stop(&wdt->wdd);
+ qcom_wdt_start(&wdt->wdd);
+ set_bit(WDOG_HW_RUNNING, &wdt->wdd.status);
+ }
+
ret = devm_watchdog_register_device(dev, &wdt->wdd);
if (ret)
return ret;
--
2.28.0
\
 
 \ /
  Last update: 2020-10-29 00:50    [W:0.021 / U:0.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site