lkml.org 
[lkml]   [2020]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 10/14] ARM: dts: sun8i: v3s: Add MIPI D-PHY and MIPI CSI-2 interface nodes
On Fri, Oct 23, 2020 at 07:45:42PM +0200, Paul Kocialkowski wrote:
> MIPI CSI-2 is supported on the V3s with an A31 controller, which seems
> to be used on all Allwinner chips supporting it, except for the A83T.
> The controller is connected to CSI0 through fwnode endpoints.
> The mipi_csi2_in port node is provided to connect MIPI CSI-2 sensors.
>
> The D-PHY part is the same that already drives DSI, but used in Rx mode.
>
> Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>

Especially since you haven't tested CSI0 without MIPI-CSI, you can
squash that patch into the previous one.

Maxime
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2020-10-26 17:56    [W:0.265 / U:3.564 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site