lkml.org 
[lkml]   [2020]   [Jan]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH for-next 0/4] dmaengine: ti: k3-udma: Updates for next
From
Date
Vinod,

On 27/01/2020 15.21, Peter Ujfalusi wrote:
> Hi Vinod,
>
> Based on customer reports we have identified two issues with the UDMA driver:
>
> TX completion (1st patch):
> The scheduled work based workaround for checking for completion worked well for
> UART, but it had significant impact on SPI performance.
> The underlying issue is coming from the fact that we have split data movement
> architecture.
> In order to know that the transfer is really done we need to check the remote
> end's (PDMA) byte counter.
>
> RX channel teardown with stale data in PDMA (2nd patch):
> If we try to stop the RX DMA channel (teardown) then PDMA is trying to flush the
> data is might received from a peripheral, but if UDMA does not have a packet to
> use for this draining than it is going to push back on the PDMA and the flush
> will never completes.
> The workaround is to use a dummy descriptor for flush purposes when the channel
> is terminated and we did not have active transfer (no descriptor for UDMA).
> This allows UDMA to drain the data and the teardown can complete.
>
> The last two patch is to use common code to set up the TR parameters for
> slave_sg, cyclic and memcpy. The setup code is the same as we used for memcpy
> with the change we can handle 4.2GB sg elements and periods in case of cyclic.
> It is also nice that we have single function to do the configuration.

I have marked these patches as for-next as 5.5 was not released yet.
Would it be possible to have these as fixes for 5.6?

Thanks,
- Péter

>
> Regards,
> Peter
> ---
> Peter Ujfalusi (3):
> dmaengine: ti: k3-udma: Workaround for RX teardown with stale data in
> peer
> dmaengine: ti: k3-udma: Move the TR counter calculation to helper
> function
> dmaengine: ti: k3-udma: Use the TR counter helper for slave_sg and
> cyclic
>
> Vignesh Raghavendra (1):
> dmaengine: ti: k3-udma: Use ktime/usleep_range based TX completion
> check
>
> drivers/dma/ti/k3-udma.c | 452 +++++++++++++++++++++++++++++----------
> 1 file changed, 343 insertions(+), 109 deletions(-)
>

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki

\
 
 \ /
  Last update: 2020-01-28 11:16    [W:0.262 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site