lkml.org 
[lkml]   [2020]   [Jan]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 5/6] at24: Support probing while off
Date
In certain use cases (where the chip is part of a camera module, and the
camera module is wired together with a camera privacy LED), powering on
the device during probe is undesirable. Add support for the at24 to
execute probe while being powered off. For this to happen, a hint in form
of a device property is required from the firmware.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
---
drivers/misc/eeprom/at24.c | 31 +++++++++++++++++++++----------
1 file changed, 21 insertions(+), 10 deletions(-)

diff --git a/drivers/misc/eeprom/at24.c b/drivers/misc/eeprom/at24.c
index 0681d5fdd538a..5fc1162b67618 100644
--- a/drivers/misc/eeprom/at24.c
+++ b/drivers/misc/eeprom/at24.c
@@ -564,6 +564,7 @@ static int at24_probe(struct i2c_client *client)
bool i2c_fn_i2c, i2c_fn_block;
unsigned int i, num_addresses;
struct at24_data *at24;
+ bool low_power;
struct regmap *regmap;
bool writable;
u8 test_byte;
@@ -701,19 +702,24 @@ static int at24_probe(struct i2c_client *client)

i2c_set_clientdata(client, at24);

- /* enable runtime pm */
- pm_runtime_set_active(dev);
+ low_power = acpi_dev_state_low_power(&client->dev);
+ if (!low_power)
+ pm_runtime_set_active(dev);
+
pm_runtime_enable(dev);

/*
- * Perform a one-byte test read to verify that the
- * chip is functional.
+ * Perform a one-byte test read to verify that the chip is functional,
+ * unless powering on the device is to be avoided during probe (i.e.
+ * it's powered off right now).
*/
- err = at24_read(at24, 0, &test_byte, 1);
- pm_runtime_idle(dev);
- if (err) {
- pm_runtime_disable(dev);
- return -ENODEV;
+ if (!low_power) {
+ err = at24_read(at24, 0, &test_byte, 1);
+ pm_runtime_idle(dev);
+ if (err) {
+ pm_runtime_disable(dev);
+ return -ENODEV;
+ }
}

if (writable)
@@ -728,8 +734,12 @@ static int at24_probe(struct i2c_client *client)

static int at24_remove(struct i2c_client *client)
{
+ bool low_power;
+
pm_runtime_disable(&client->dev);
- pm_runtime_set_suspended(&client->dev);
+ low_power = acpi_dev_state_low_power(&client->dev);
+ if (!low_power)
+ pm_runtime_set_suspended(&client->dev);

return 0;
}
@@ -743,6 +753,7 @@ static struct i2c_driver at24_driver = {
.probe_new = at24_probe,
.remove = at24_remove,
.id_table = at24_ids,
+ .probe_low_power = true,
};

static int __init at24_init(void)
--
2.20.1
\
 
 \ /
  Last update: 2020-01-21 14:43    [W:0.113 / U:0.432 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site