lkml.org 
[lkml]   [2019]   [Sep]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 5/5] ARM: dts: ls1021a-tsn: Use the DSPI controller in poll mode
On Tue, Aug 27, 2019 at 09:16:39PM +0300, Vladimir Oltean wrote:
> On Tue, 27 Aug 2019 at 21:13, Mark Brown <broonie@kernel.org> wrote:
> >
> > On Tue, Aug 27, 2019 at 09:06:14PM +0300, Vladimir Oltean wrote:
> > > On Tue, 27 Aug 2019 at 21:05, Mark Brown <broonie@kernel.org> wrote:
> > > > On Mon, Aug 26, 2019 at 04:10:51PM +0300, Vladimir Oltean wrote:
> >
> > > > > I noticed you skipped applying this patch, and I'm not sure that Shawn
> > > > > will review it/take it.
> > > > > Do you have a better suggestion how I can achieve putting the DSPI
> > > > > driver in poll mode for this board? A Kconfig option maybe?
> >
> > > > DT changes go through the relevant platform trees, not the
> > > > subsystem trees, so it's not something I'd expect to apply.
> >
> > > But at least is it something that you expect to see done through a
> > > device tree change?
> >
> > Well, it's not ideal - if it performs better all the time the
> > driver should probably just do it unconditionally. If there's
> > some threashold where it tends to perform better then the driver
> > should check for that but IIRC it sounds like the interrupt just
> > isn't at all helpful here.
>
> I can't seem to find any situation where it performs worse. Hence my
> question on whether it's a better idea to condition this behavior on a
> Kconfig option rather than a DT blob which may or may not be in sync.

DT is a description of hardware not condition for software behavior,
where module parameter is usually used for.

Shawn

\
 
 \ /
  Last update: 2019-09-11 08:34    [W:0.212 / U:1.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site