lkml.org 
[lkml]   [2019]   [Aug]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v4 7/7] PCI: dwc: Add validation that PCIe core is set to correct mode
On Thu, Aug 22, 2019 at 04:30:09PM +0000, Chocron, Jonathan wrote:
> On Thu, 2019-08-22 at 12:13 +0100, Andrew Murray wrote:
> > On Wed, Aug 21, 2019 at 06:47:45PM +0300, Jonathan Chocron wrote:
> > > Some PCIe controllers can be set to either Host or EP according to
> > > some
> > > early boot FW. To make sure there is no discrepancy (e.g. FW
> > > configured
> > > the port to EP mode while the DT specifies it as a host bridge or
> > > vice
> > > versa), a check has been added for each mode.
> > >
> > > Signed-off-by: Jonathan Chocron <jonnyc@amazon.com>
> > > Acked-by: Gustavo Pimentel <gustavo.pimentel@synopsys.com>
> > > ---
> > > drivers/pci/controller/dwc/pcie-designware-ep.c | 8 ++++++++
> > > drivers/pci/controller/dwc/pcie-designware-host.c | 8 ++++++++
> > > 2 files changed, 16 insertions(+)
> > >
> > > diff --git a/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > index 2bf5a35c0570..00e59a134b93 100644
> > > --- a/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > +++ b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > @@ -531,6 +531,7 @@ int dw_pcie_ep_init(struct dw_pcie_ep *ep)
> > > int ret;
> > > u32 reg;
> > > void *addr;
> > > + u8 hdr_type;
> > > unsigned int nbars;
> > > unsigned int offset;
> > > struct pci_epc *epc;
> > > @@ -543,6 +544,13 @@ int dw_pcie_ep_init(struct dw_pcie_ep *ep)
> > > return -EINVAL;
> > > }
> > >
> > > + hdr_type = dw_pcie_readb_dbi(pci, PCI_HEADER_TYPE);
> > > + if (hdr_type != PCI_HEADER_TYPE_NORMAL) {
> > > + dev_err(pci->dev, "PCIe controller is not set to EP
> > > mode (hdr_type:0x%x)!\n",
> > > + hdr_type);
> > > + return -EIO;
> > > + }
> > > +
> > > ret = of_property_read_u32(np, "num-ib-windows", &ep-
> > > >num_ib_windows);
> > > if (ret < 0) {
> > > dev_err(dev, "Unable to read *num-ib-windows*
> > > property\n");
> > > diff --git a/drivers/pci/controller/dwc/pcie-designware-host.c
> > > b/drivers/pci/controller/dwc/pcie-designware-host.c
> > > index f93252d0da5b..d2ca748e4c85 100644
> > > --- a/drivers/pci/controller/dwc/pcie-designware-host.c
> > > +++ b/drivers/pci/controller/dwc/pcie-designware-host.c
> > > @@ -323,6 +323,7 @@ int dw_pcie_host_init(struct pcie_port *pp)
> > > struct pci_bus *child;
> > > struct pci_host_bridge *bridge;
> > > struct resource *cfg_res;
> > > + u8 hdr_type;
> > > int ret;
> > >
> > > raw_spin_lock_init(&pci->pp.lock);
> > > @@ -396,6 +397,13 @@ int dw_pcie_host_init(struct pcie_port *pp)
> > > }
> > > }
> > >
> > > + hdr_type = dw_pcie_readb_dbi(pci, PCI_HEADER_TYPE);
> >
> > Do we know if it's always safe to read these registers at this point
> > in time?
> >
> > Later in dw_pcie_host_init we call pp->ops->host_init - looking at
> > the
> > implementations of .host_init I can see:
> >
> > - resets being performed (qcom_ep_reset_assert,
> > artpec6_pcie_assert_core_reset, imx6_pcie_assert_core_reset)
> > - changes to config space registers (ks_pcie_init_id,
> > dw_pcie_setup_rc)
> > including setting PCI_CLASS_DEVICE
> > - and clocks being enabled (qcom_pcie_init_1_0_0)
> >
> Good point! This indeed might break host drivers which actually setup
> the rc in the kernel, and don't depend on early boot FW. So the
> validation should probably be moved to after pp->ops->host_init() (and
> similarly after ep->ops->ep_init() for the ep driver), right?

Yes I think so.


>
> > I'm not sure if your changes would cause anything to break for these
> > other
> > controllers (or future controllers) as I couldn't see any other reads
> > to the
> > config.
> >
> > Given that we are reading config space should dw_pcie_rd_own_conf be
> > used?
>
> The config space of the DW core is located at the beginning of the DBI
> regspace. Furthermore, this would break the "symmetry" between the host
> and ep validations (since the ep has no notion of reading from config
> space nor a .read callback in struct dw_pcie_ep_ops).

This is true, though given how different the two drivers are - this is only
really 'nice to have'.


> I agree that
> there is some sort of overlap between the dw_pcie_read{/write}_dbi
> dw_pcie_rd{/wr}_own_conf APIs, when accessing the host mode config
> space, but I assume that any host driver which supplies a callback for
> .rd_own_conf() must supply an equivalent .read_dbi() one as well.
> > (For example kirin_pcie_rd_own_conf does something special).
> >
> They specifically define an equivalent kirin_pcie_read_dbi().

This may also be true. However given that the dwc framework gives host drivers
the ability to provide their own rd_own_conf callback - it's very possible
that these drivers can use the callback to handle quirks - now or in the
future. Potentially a quirk that your direct reading won't handle.

Looking at the existing drivers which provide a .rd_own_conf:

pci-exynos.c:
- Uses dw_pcie_read to directly read from registers, sandwich'd between writes
to set/clear PCIE_ELBI_SLV_ARMISC. This driver provides a .read_dbi which
means dw_pcie_readb_dbi probably does the same thing as rd_own_conf.

pci-menson.c:
- Uses dw_pcie_read to directly read from registers, it then applies a read
quirk for the PCI_CLASS_DEVICE register. This driver doesn't provide a
.read_dbi - thus dw_pcie_readb_dbi probably does the same thing as
rd_own_conf provided you don't read the PCI_CLASS_DEVICE register.

pcie-hisi.c:
- Uses dw_pcie_readl_dbi to read from registers, but the controller only
supports 32bit aligned reads - it doesn't provide a .read_dbi. This means
that if you used dw_pcie_readb_dbi it'd probably break because you can't
read 1 byte at the offset where HEADER_TYPE is.

pcie-histb.c, pcie-kirin.c: looks like pci-exynos.c

It looks like we're going to have to break symmetry...

Thanks,

Andrew Murray

>
> > Thanks,
> >
> > Andrew Murray
> >
> > > + if (hdr_type != PCI_HEADER_TYPE_BRIDGE) {
> > > + dev_err(pci->dev, "PCIe controller is not set to bridge
> > > type (hdr_type: 0x%x)!\n",
> > > + hdr_type);
> > > + return -EIO;
> > > + }
> > > +
> > > pp->mem_base = pp->mem->start;
> > >
> > > if (!pp->va_cfg0_base) {
> > > --
> > > 2.17.1
> > >

\
 
 \ /
  Last update: 2019-08-27 11:49    [W:0.085 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site