lkml.org 
[lkml]   [2019]   [Aug]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCHv5] drivers/amba: add reset control to amba bus probe
Date
On Mon, 26 Aug 2019 10:42:52 -0500, Dinh Nguyen said:
> The primecell controller on some SoCs, i.e. SoCFPGA, is held in reset by
> default. Until recently, the DMA controller was brought out of reset by the
> bootloader(i.e. U-Boot). But a recent change in U-Boot, the peripherals
> that are not used are held in reset and are left to Linux to bring them
> out of reset.
>
> Add a mechanism for getting the reset property and de-assert the primecell
> module from reset if found. This is a not a hard fail if the reset properti
> is not present in the device tree node, so the driver will continue to
> probe.

Does this DTRT for both old and new U-Boots? My naive reading of this patch
says on an old U-Boot, we end up attempting to bring it out of reset even though
they had already been brought out.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-08-27 21:26    [W:0.047 / U:2.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site