lkml.org 
[lkml]   [2019]   [Aug]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RESEND PATCH v3 14/20] mtd: spi_nor: Add a ->setup() method
Date
On 26.08.19 14:40, Boris Brezillon wrote:
> On Mon, 26 Aug 2019 12:08:58 +0000
> <Tudor.Ambarus@microchip.com> wrote:
>
>> From: Tudor Ambarus <tudor.ambarus@microchip.com>
>>
>> nor->params.setup() configures the SPI NOR memory. Useful for SPI NOR
>> flashes that have peculiarities to the SPI NOR standard, e.g.
>> different opcodes, specific address calculation, page size, etc.
>> Right now the only user will be the S3AN chips, but other
>> manufacturers can implement it if needed.
>>
>> Move spi_nor_setup() related code in order to avoid a forward
>> declaration to spi_nor_default_setup().
>>
>> Reviewed-by: Boris Brezillon <boris.brezillon@collabora.com>
>
> Nitpick: R-bs should normally be placed after your SoB.

Just a question unrelated to the patch content:

I learned to add R-b tags after my SoB when submitting MTD patches, but
recently I submitted a patch to the serial subsystem and was told to put
my SoB last. Is there an "official" rule for this? And if so where to
find it?

>
>> Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
>> ---
>
> ______________________________________________________
> Linux MTD discussion mailing list
> http://lists.infradead.org/mailman/listinfo/linux-mtd/
>
\
 
 \ /
  Last update: 2019-08-26 15:39    [W:0.268 / U:1.076 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site