lkml.org 
[lkml]   [2019]   [Jul]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] net: dsa: mv88e6xxx: add support to setup led-control register through device-tree
On Tue, Jul 30, 2019 at 12:14:50PM +0200, Hubert Feurstein wrote:
> So it is possible to change the default behaviour of the switch LEDs.

Sorry, but this is not going to be accepted. There is an ongoing
discussion about PHY LEDs and how they should be configured. Switch
LEDs are no different from PHY LEDs. So they should use the same basic
concept.

Please take a look at the discussion around:

[RFC] dt-bindings: net: phy: Add subnode for LED configuration

Marvell designers have made this more difficult than it should be by
moving the registers out of the PHY address space and into the switch
address space. So we are going to have to implement this code twice
:-(

Andrew

\
 
 \ /
  Last update: 2019-07-30 16:10    [W:0.054 / U:0.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site