Messages in this thread Patch in this message | | | From | Greg Kroah-Hartman <> | Subject | [PATCH 5.2 006/413] ath10k: Do not send probe response template for mesh | Date | Wed, 24 Jul 2019 21:14:57 +0200 |
| |
[ Upstream commit 97354f2c432788e3163134df6bb144f4b6289d87 ]
Currently mac80211 do not support probe response template for mesh point. When WMI_SERVICE_BEACON_OFFLOAD is enabled, host driver tries to configure probe response template for mesh, but it fails because the interface type is not NL80211_IFTYPE_AP but NL80211_IFTYPE_MESH_POINT.
To avoid this failure, skip sending probe response template to firmware for mesh point.
Tested HW: WCN3990/QCA6174/QCA9984
Signed-off-by: Surabhi Vishnoi <svishnoi@codeaurora.org> Signed-off-by: Kalle Valo <kvalo@codeaurora.org> Signed-off-by: Sasha Levin <sashal@kernel.org> --- drivers/net/wireless/ath/ath10k/mac.c | 4 ++++ 1 file changed, 4 insertions(+)
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index e8997e22ceec..b500fd427595 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -1630,6 +1630,10 @@ static int ath10k_mac_setup_prb_tmpl(struct ath10k_vif *arvif) if (arvif->vdev_type != WMI_VDEV_TYPE_AP) return 0; + /* For mesh, probe response and beacon share the same template */ + if (ieee80211_vif_is_mesh(vif)) + return 0; + prb = ieee80211_proberesp_get(hw, vif); if (!prb) { ath10k_warn(ar, "failed to get probe resp template from mac80211\n"); -- 2.20.1
| |