Messages in this thread | | | Subject | Re: [PATCH v3 0/5] arch: riscv: add board and SoC DT file support | From | Atish Patra <> | Date | Thu, 6 Jun 2019 16:15:40 -0700 |
| |
On 6/5/19 10:37 AM, Kevin Hilman wrote: > Hi Paul, > > Paul Walmsley <paul.walmsley@sifive.com> writes: > >> Add support for building flattened DT files from DT source files under >> arch/riscv/boot/dts. Follow existing kernel precedent from other SoC >> architectures. Start our board support by adding initial support for >> the SiFive FU540 SoC and the first development board that uses it, the >> SiFive HiFive Unleashed A00. >> >> This third version of the patch set adds I2C data for the chip, >> incorporates all remaining changes that riscv-pk was making >> automatically, and addresses a comment from Rob Herring >> <robh@kernel.org>. >> >> Boot-tested on v5.2-rc1 on a HiFive Unleashed A00 board, using the >> BBL and open-source FSBL, with modifications to pass in the DTB >> file generated by these patches. > > Tested this series on top of v5.2-rc3 on HiFive Unleashed board using > OpenSBI + mainline u-boot (master branch as of today). > > Tested-by: Kevin Hilman <khilman@baylibre.com> > >> This patch series can be found, along with the PRCI patch set >> and the DT macro prerequisite patch, at: >> >> https://github.com/sifive/riscv-linux/tree/dev/paulw/dts-v5.2-rc1 > > nit: I only see this series in that branch, not any of the prerequisite > patches you mentioned, which made me assume I could this series alone on > top of v5.2-rc3, which worked just fine. >
I tried only this series on top of v5.2-rc3. Kernel boots file with DT updated via U-Boot. But networking didn't come up.
Do you have networking up after the boot? If yes, can you please share the config.
> Kevin > > _______________________________________________ > linux-riscv mailing list > linux-riscv@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-riscv >
-- Regards, Atish
| |