lkml.org 
[lkml]   [2019]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/4] powerpc/powernv: remove the unused pnv_pci_set_p2p function
On Tue, Jun 25, 2019 at 10:26:03AM +0200, Cédric Le Goater wrote:
> > @@ -280,13 +280,6 @@ int64_t opal_xive_allocate_irq(uint32_t chip_id);
> > int64_t opal_xive_free_irq(uint32_t girq);
> > int64_t opal_xive_sync(uint32_t type, uint32_t id);
> > int64_t opal_xive_dump(uint32_t type, uint32_t id);
> > -int64_t opal_xive_get_queue_state(uint64_t vp, uint32_t prio,
> > - __be32 *out_qtoggle,
> > - __be32 *out_qindex);
> > -int64_t opal_xive_set_queue_state(uint64_t vp, uint32_t prio,
> > - uint32_t qtoggle,
> > - uint32_t qindex);
> > -int64_t opal_xive_get_vp_state(uint64_t vp, __be64 *out_w01);
>
>
> This hunk seems unrelated.
>
> These OPAL calls are new. They are used by the XIVE KVM device
> to get/set the interrupt controller state of a guest.
>
>
> > int64_t opal_pci_set_p2p(uint64_t phb_init, uint64_t phb_target,
> > uint64_t desc, uint16_t pe_number);
>
> I suppose this is the one ^ you wanted to remove.

Thanks. I'm pretty sure I had this fixed up before due to a builtbot
warning, but somehow the old version popped up again.

\
 
 \ /
  Last update: 2019-06-25 10:29    [W:0.062 / U:0.976 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site