lkml.org 
[lkml]   [2019]   [Jun]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 11/17] riscv: read hart ID from mhartid on boot
Date
From: Damien Le Moal <damien.lemoal@wdc.com>

When in M-Mode, we can use the mhartid CSR to get the ID of the running
HART. Doing so, direct M-Mode boot without firmware is possible.

Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
---
arch/riscv/kernel/head.S | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/arch/riscv/kernel/head.S b/arch/riscv/kernel/head.S
index cb5691d82b0b..e05379fd8b64 100644
--- a/arch/riscv/kernel/head.S
+++ b/arch/riscv/kernel/head.S
@@ -25,6 +25,14 @@ ENTRY(_start)
/* Reset all registers except ra, a0,a1 */
call reset_regs

+#ifdef CONFIG_M_MODE
+ /*
+ * The hartid in a0 is expected later on, and we have no firmware
+ * to hand it to us.
+ */
+ csrr a0, mhartid
+#endif
+
/* Load the global pointer */
.option push
.option norelax
--
2.20.1
\
 
 \ /
  Last update: 2019-06-11 00:17    [W:0.132 / U:0.272 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site