lkml.org 
[lkml]   [2019]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 0/2] hwmon: scmi: Scale values to target desired HWMON units
On Tue, May 07, 2019 at 04:09:15PM -0700, Florian Fainelli wrote:
> Hi Sudeep, Guenter,
>
> This patch series adds support for scaling SCMI sensor values read from
> firmware. Sudeep, let me know if you think we should be treating scale
> == 0 as a special value to preserve some firmware compatibility (not
> that this would be desired).

So are we providing raw values from sensors.c and handling conversion
in hwmon layer ? I was thinking of just providing converted values
to hwmon just in case if the scaling thing change in future with
newer versions of SCMI. I am fine either way, just trying to keep
hwmon-scmi simpler. I will check if scale = 0 needs to be treated as
special(I don't think so, but will read the spec)

--
Regards,
Sudeep

\
 
 \ /
  Last update: 2019-05-08 13:37    [W:0.071 / U:0.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site