lkml.org 
[lkml]   [2019]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectRE: [EXT] Re: [PATCH v5 2/5] usb: phy: Workaround for USB erratum-A005728
Date


> -----Original Message-----
> From: Alan Stern [mailto:stern@rowland.harvard.edu]
> Sent: 2019年5月8日 22:15
> To: Yinbo Zhu <yinbo.zhu@nxp.com>
> Cc: Xiaobo Xie <xiaobo.xie@nxp.com>; Greg Kroah-Hartman
> <gregkh@linuxfoundation.org>; Ramneek Mehresh
> <ramneek.mehresh@freescale.com>; Nikhil Badola
> <nikhil.badola@freescale.com>; Ran Wang <ran.wang_1@nxp.com>;
> linux-usb@vger.kernel.org; linux-kernel@vger.kernel.org; Jiafei Pan
> <jiafei.pan@nxp.com>; Suresh Gupta <B42813@freescale.com>
> Subject: [EXT] Re: [PATCH v5 2/5] usb: phy: Workaround for USB
> erratum-A005728
>
> Caution: EXT Email
>
> On Wed, 8 May 2019, Yinbo Zhu wrote:
>
> > From: Suresh Gupta <B42813@freescale.com>
> >
> > PHY_CLK_VALID bit for UTMI PHY in USBDR does not set even if PHY is
> > providing valid clock. Workaround for this involves resetting of PHY
> > and check PHY_CLK_VALID bit multiple times. If PHY_CLK_VALID bit is
> > still not set even after 5 retries, it would be safe to deaclare that
> > PHY clock is not available.
> > This erratum is applicable for USBDR less then ver 2.4.
> >
> > Signed-off-by: Suresh Gupta <B42813@freescale.com>
> > Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
> > ---
> > Change in v5:
> > remove dev_err function unnecessary parameters
> >
> > drivers/usb/host/ehci-fsl.c | 37 ++++++++++++++++++++++++++-----------
> > drivers/usb/host/ehci-fsl.h | 3 +++
> > 2 files changed, 29 insertions(+), 11 deletions(-)
> >
> > diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
> > index 38674b7..1634ac8 100644
> > --- a/drivers/usb/host/ehci-fsl.c
> > +++ b/drivers/usb/host/ehci-fsl.c
> > @@ -183,6 +183,17 @@ static int fsl_ehci_drv_probe(struct platform_device
> *pdev)
> > return retval;
> > }
> >
> > +static bool usb_phy_clk_valid(struct usb_hcd *hcd) {
> > + void __iomem *non_ehci = hcd->regs;
> > + bool ret = true;
> > +
> > + if (!(ioread32be(non_ehci + FSL_SOC_USB_CTRL) & PHY_CLK_VALID))
> > + ret = false;
> > +
> > + return ret;
> > +}
> > +
> > static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
> > enum fsl_usb2_phy_modes phy_mode,
> > unsigned int port_offset) @@ -226,6
> > +237,16 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
> > /* fall through */
> > case FSL_USB2_PHY_UTMI:
> > case FSL_USB2_PHY_UTMI_DUAL:
> > + /* PHY_CLK_VALID bit is de-featured from all controller
> > + * versions below 2.4 and is to be checked only for
> > + * internal UTMI phy
> > + */
> > + if (pdata->controller_ver > FSL_USB_VER_2_4 &&
> > + pdata->have_sysif_regs && !usb_phy_clk_valid(hcd)) {
> > + dev_err(dev, "USB PHY clock invalid\n");
> > + return -EINVAL;
> > + }
> > +
> > if (pdata->have_sysif_regs && pdata->controller_ver) {
> > /* controller version 1.6 or above */
> > tmp = ioread32be(non_ehci + FSL_SOC_USB_CTRL);
> > @@ -249,17 +270,11 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
> > break;
> > }
> >
> > - /*
> > - * check PHY_CLK_VALID to determine phy clock presence before writing
> > - * to portsc
> > - */
> > - if (pdata->check_phy_clk_valid) {
> > - if (!(ioread32be(non_ehci + FSL_SOC_USB_CTRL) &
> > - PHY_CLK_VALID)) {
> > - dev_warn(hcd->self.controller,
> > - "USB PHY clock invalid\n");
> > - return -EINVAL;
> > - }
> > + if (pdata->have_sysif_regs &&
> > + pdata->controller_ver > FSL_USB_VER_1_6 &&
> > + !usb_phy_clk_valid(hcd)) {
>
> This is still wrong. The line above should be indented four characters less than it
> is: the '!' should line up with the 'p' in the line above it.
>
> Alan Stern
Hi Alan Stern,

Your meaning is that as following changes?
+ if (pdata->have_sysif_regs &&
+ pdata->controller_ver > FSL_USB_VER_1_6 &&
+ !usb_phy_clk_valid(hcd)) {

Regards,
Yinbo
>
> > + dev_warn(hcd->self.controller, "USB PHY clock invalid\n");
> > + return -EINVAL;
> > }
> >
> > ehci_writel(ehci, portsc,
> > &ehci->regs->port_status[port_offset]);
> > diff --git a/drivers/usb/host/ehci-fsl.h b/drivers/usb/host/ehci-fsl.h
> > index cbc4220..9d18c6e 100644
> > --- a/drivers/usb/host/ehci-fsl.h
> > +++ b/drivers/usb/host/ehci-fsl.h
> > @@ -50,4 +50,7 @@
> > #define UTMI_PHY_EN (1<<9)
> > #define ULPI_PHY_CLK_SEL (1<<10)
> > #define PHY_CLK_VALID (1<<17)
> > +
> > +/* Retry count for checking UTMI PHY CLK validity */ #define
> > +UTMI_PHY_CLK_VALID_CHK_RETRY 5
> > #endif /* _EHCI_FSL_H */
> >

\
 
 \ /
  Last update: 2019-05-09 05:55    [W:0.040 / U:0.336 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site