Messages in this thread | | | Date | Sat, 25 May 2019 11:17:14 -0700 | From | Bjorn Andersson <> | Subject | Re: [PATCH v7 2/4] soc: qcom: Add AOSS QMP driver |
| |
On Sat 25 May 10:53 PDT 2019, Sai Prakash Ranjan wrote:
> On 5/1/2019 10:07 AM, Bjorn Andersson wrote: > > The Always On Subsystem (AOSS) Qualcomm Messaging Protocol (QMP) driver > > is used to communicate with the AOSS for certain side-channel requests, > > that are not available through the RPMh interface. > > > > The communication is a very simple synchronous mechanism of messages > > being written in message RAM and a doorbell in the AOSS is rung. As the > > AOSS has processed the message length is cleared and an interrupt is > > fired by the AOSS as acknowledgment. > > > > The driver exposes the QDSS clock as a clock and the low-power state > > associated with the remoteprocs in the system as a set of power-domains. > > > > Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> > > --- > > > > Changes since v6: > > - Squash the pd into the same driver as the communication, to simplify > > the interaction. > > - Representing the QDSS clocks as a clock/power domain turns out to > > cascade into a request to make all Coresight drivers have a secondary > > compatible to replace the required bus clock with a required power > > domain. So in v7 this is exposed as a clock instead. > > - Some error checking updates, as reported by Doug. > > > > Thanks for the patch Bjorn. > Tested the QDSS functionality on SDM845 based Cheza board with this > change and it works just fine. > > Tested-by: Sai Prakash Ranjan <saiprakash.ranjan@codeaurora.org>
Thanks for the confirmation Sai!
Regards, Bjorn
| |