Messages in this thread | | | Date | Thu, 4 Apr 2019 09:47:00 +0200 | From | Horatiu Vultur <> | Subject | Re: [PATCH net-next] MIPS: generic: Add switchdev, pinctrl and fit to ocelot_defconfig |
| |
Hi Paul,
The 04/03/2019 23:23, Paul Burton wrote: > External E-Mail > > > Hi Horatiu, > > On Wed, Apr 03, 2019 at 05:27:36PM +0200, Horatiu Vultur wrote: > > diff --git a/arch/mips/configs/generic/board-ocelot.config b/arch/mips/configs/generic/board-ocelot.config > > index f607888..3215741 100644 > > --- a/arch/mips/configs/generic/board-ocelot.config > > +++ b/arch/mips/configs/generic/board-ocelot.config > >% > > +# CONFIG_HID is not set > > +# CONFIG_USB_SUPPORT is not set > > +# CONFIG_VIRTIO_MENU is not set > > +# CONFIG_SCSI is not set > > Unfortunately this part won't work so well. If board-ocelot.config > disables these things, then what should happen if another board that's > also included in a generic kernel enables them? > > eg. if you run 'make ARCH=mips 32r2el_defconfig' then we merge all of > the following: > > board-boston.config enables USB > board-sead-3.config enables USB > board-ocelot.config disables USB
I didn't think about this scenario, because I didn't expect that building a generic configuration will bring together all the board configurations.
Anyway, I will send a new patch in which I will remove these configurations.
> > These are mutually exclusive, and it seems that on my system we > currently end up disabling USB due to board-ocelot.config. That will of > course break USB support for Boston or SEAD-3 which are also supported > by the same kernel binary. In practice which one 'wins' will depend on > the order the files are listed by make's wildcard function - so far as > I'm aware that doesn't guarantee any particular order so if it ends up > depending on the order the filesystem lists the files or something like > that then configurations might even differ when used on different > machines. > > So to avoid that the best we can do is leave these enabled and the > general rule is that board-*.config files can only enable extra things, > not disable them. > > You might be tempted to disable the options in generic_defconfig & > update any board configs that actually need them to enable them, but > that doesn't work too well for things which are 'default y' because > kconfig then warns about the conflict between generic_defconfig & the > board config being merged with it. That applies to the first 3 of the > entries you disable, leaving only CONFIG_SCSI that could potentially be > dealt with that way... > > Thanks, > Paul >
-- /Horatiu
| |