lkml.org 
[lkml]   [2019]   [Apr]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
SubjectRe: [PATCH v2 2/3] power: supply: Add driver for Microchip UCS1002
From
Date
Hi Andrey,

Am Sonntag, den 28.04.2019, 22:47 -0700 schrieb Andrey Smirnov:
> Add driver for Microchip UCS1002 Programmable USB Port Power
> Controller with Charger Emulation. The driver exposed a power supply
> device to control/monitor various parameter of the device as well as a
> regulator to allow controlling VBUS line.
>
> > Signed-off-by: Enric Balletbo Serra <enric.balletbo@collabora.com>
> > Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
> > Cc: Chris Healy <cphealy@gmail.com>
> > Cc: Lucas Stach <l.stach@pengutronix.de>
> > Cc: Fabio Estevam <fabio.estevam@nxp.com>
> > Cc: Guenter Roeck <linux@roeck-us.net>
> > Cc: Sebastian Reichel <sre@kernel.org>
> Cc: linux-kernel@vger.kernel.org
> Cc: linux-pm@vger.kernel.org
> ---
[...]
> + /* Enable charge rationing by default */
> > + ret = regmap_update_bits(info->regmap, UCS1002_REG_GENERAL_CFG,
> > +  F_RATION_EN, F_RATION_EN);
> > + if (ret) {
> > + dev_err(dev, "Failed to read general config: %d\n", ret);
> > + return ret;
> > + }
> +
> > + /*
> > +  * Ignore the M1, M2, PWR_EN, and EM_EN pin states. Set active
> > +  * mode selection to BC1.2 CDP.
> > +  */
> > + ret = regmap_update_bits(info->regmap, UCS1002_REG_SWITCH_CFG,
> > +  V_SET_ACTIVE_MODE_MASK,
> +  V_SET_ACTIVE_MODE_BC12_CDP);

This doesn't work as the F_PIN_IGNORE bit isn't set, so the the
external strap settings are applied. I had to apply the following diff
to make the driver behave as expected again:

--- a/drivers/power/supply/ucs1002_power.c
+++ b/drivers/power/supply/ucs1002_power.c
@@ -548,8 +548,8 @@ static int ucs1002_probe(struct i2c_client *client,
         * mode selection to BC1.2 CDP.
         */
        ret = regmap_update_bits(info->regmap, UCS1002_REG_SWITCH_CFG,
-                                V_SET_ACTIVE_MODE_MASK,
-                                V_SET_ACTIVE_MODE_BC12_CDP);
+                                V_SET_ACTIVE_MODE_MASK | F_PIN_IGNORE,
+                                V_SET_ACTIVE_MODE_BC12_CDP | F_PIN_IGNORE);

Regards,
Lucas

\
 
 \ /
  Last update: 2019-04-29 12:28    [W:0.045 / U:0.376 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site